Search

Prof. Dr. Panne's ambition as an editor for ABC is to demonstrate that good analytical chemistry is at the core of many fundamental and applied scientific problems and innovations and will contribute to solving the grand challenges of our times. We continue to have a dynamic team of editors at ABC. [Extracted from the article]

This research proposes a low-cost and simple operation microfluidic chip to enhance the magnetic labeling efficiency of two ischemic stroke biomarkers: cellular fibronectin (c-Fn) and matrix metallopeptidase 9 (MMP9). This fully portable and pump-free microfluidic chip is operated based on capillary attractions without any external power source and battery. It uses an integrated cellulose sponge to absorb the samples. At the same time, a magnetic field is aligned to hold the target labeled by the magnetic nanoparticles (MNPs) in the pre-concentrated chamber. By using this approach, the specific targets are labeled from the beginning of the sampling process without preliminary sample purification. The proposed study enhanced the labeling efficiency from 1 h to 15 min. The dynamic interactions occur in the serpentine channel, while the crescent formation of MNPs in the pre-concentrated chamber, acting as a magnetic filter, improves the biomarker-MNP interaction. The labeling optimization by the proposed device influences the dynamic range by optimizing the MNP ratio to fit the linear range across the clinical cutoff value. The limits of detection (LODs) of 2.8 ng/mL and 54.6 ng/mL of c-Fn measurement were achieved for undiluted and four times dilutions of MNP, respectively. While for MMP9, the LODs were 11.5 ng/mL for undiluted functionalized MNP and 132 ng/mL for four times dilutions of functionalized MNP. The results highlight the potential use of this device for clinical sample preparation and specific magnetic target labeling. When combined with a detection system, it could also be used as an integrated component of a point-of-care platform. [ABSTRACT FROM AUTHOR]

The green microalga Haematococcus pluvialis has been widely studied due to its capacity to accumulate great amounts of astaxanthin, a high-value carotenoid with biological activities. In the present work, two green compressed fluid–based processes, pressurized liquid extraction (PLE) and supercritical antisolvent fractionation (SAF), are integrated to obtain an astaxanthin-enriched extract from this microalga. PLE was carried out using pressurized ethanol as solvent, for 20 min, at 10 MPa, and 50 °C as extraction temperature. Subsequently, the obtained extract was processed by SAF to further purify the carotenoid fraction. The SAF process was optimized using a 3-level factorial experimental design and considering three experimental variables: (i) CO2 pressure (10–30 MPa), (ii) percentage of water in the PLE extract (20–50%), and (iii) PLE extract/supercritical-CO2 flow rate ratio (0.0125–0.05). Total carotenoid content was evaluated in both extracts and raffinates. Best results were obtained at 30 MPa, 0.05 feed/SC-CO2 mass flow rate, and 20% (v/v) of water in the feed solution, achieving values of 120.3 mg g−1 carotenoids in extract (in the SAF extract fraction), which were significantly higher than those obtained in the original PLE extract. In parallel, a new fast two-dimensional comprehensive liquid chromatography (LC×LC) method was optimized to get the full carotenoid profile of these extracts in less than 25 min. This is the first time that the use of a C30 column is reported in an on-line LC×LC system. [ABSTRACT FROM AUTHOR]

Saponins are secondary metabolites that are abundant and diversified in echinoderms. Mass spectrometry is increasingly used not only to identify saponin congeners within animal extracts but also to decipher the structure/biological activity relationships of these molecules by determining their inter-organ and inter-individual variability. The usual method requires extensive purification procedures to prepare saponin extracts compatible with mass spectrometry analysis. Here, we selected the sea star Asterias rubens as a model animal to prove that direct analysis of saponins can be performed on tissue sections. We also demonstrated that carboxymethyl cellulose can be used as an embedding medium to facilitate the cryosectioning procedure. Matrix-assisted laser desorption/ionization (MALDI) imaging was also revealed to afford interesting data on the distribution of saponin molecules within the tissues. We indeed highlight that saponins are located not only inside the body wall of the animals but also within the mucus layer that probably protects the animal against external aggressions. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]

Age of individual uranium-plutonium (U/Pu) mixed particles with various U/Pu atomic ratios (1-70) were determined by inductively coupled plasma mass spectrometry. Micron-sized particles were prepared from U and Pu certified reference materials. The Pu reference was stored for 4-6 years since the last purification (July 14, 2008). The Pu purification age was obtained from the Am/Pu ratio which was calculated from the product of three measured ratios of Pu and Am isotopes in the eluted fractions. These ratios were measured by a high-resolution inductively coupled plasma mass spectrometer equipped with a desolvation system. Femto-gram to pico-gram quantities of Am, U, and Pu in a sample solution were sequentially separated on a small anion-exchange column. The Am/Pu ratio was accurately determined by spiking pure Am into the sample solution. The average determined age for the particles for the five independent U/Pu ratios was in good agreement with the expected age with high accuracy (difference age 0.27 years) and high precision (standard deviation 0.44 years). The described analytical technique can serve as an effective tool for nuclear safeguards and environmental radiochemistry. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]

A three-stage linear gradient strategy using reverse-phase high-performance liquid chromatography (HPLC) was optimized for rapid, high-quality, and simultaneous purification of the lipopeptide isoforms of iturin, fengycin, and surfactin, which may differ in composition by only a single amino acid and/or the fatty acid residue. Matrix-assisted laser desorption ionization time-of-flight tandem mass spectrometry (MALDI-TOF-MS/MS) was applied to detect the lipopeptides harvested from each reversed-phase HPLC peak. Amino acid analysis based on phenyl isothiocyanate derivatization was further used for confirmation of the amino acid species and molar ratio in a certain HPLC fraction. By this MALDI-TOF-MS/MS coupled with amino acid analysis, it was revealed that iturin at m/ z 1,043 consists of a circular Asn-Tyr-Asn-Gln-Pro-Asn-Ser peptide and C β-OH fatty acid. Surfactin homologs from Bacillus subtilis THY-7 at m/ z 1,030, 1,044, 1,058, and 1,072 possess a circular Glu-Leu-Leu-Val-Asp-Leu-Leu peptide and the β-OH fatty acid with a different length (C-C). Fengycin species at m/ z 1,463 and 1,477 are homologs possessing the circular peptide Glu-Orn-Tyr-Thr-Glu-Ala-Pro-Gln-Tyr-Ile linked to a C or C γ-OH fatty acid, whereas fengycin at m/ z 1,505 contains a Glu-Orn-Tyr-Thr-Glu-Val-Pro-Gln-Tyr-Ile sequence with a Val instead of Ala at position 6. The method developed in this work provided an efficient approach for characterization of diverse lipopeptide isoforms from the iturin, fengycin, and surfactin families. [ABSTRACT FROM AUTHOR]

Saponins are widely distributed in the plant kingdom and have been shown to be active components of many medicinal herbs. In this study, a two-dimensional purification method based on reversed-phase liquid chromatography coupled with hydrophilic interaction liquid chromatography was successfully applied to purify saponins from leaves of Panax notoginseng. Nine saponin reference standards were used to test the separation modes and columns. The standards could not be resolved using C columns owing to their limited polar selectivity. However, they were completely separated on a XAmide column in hydrophilic interaction liquid chromatography mode, including two pairs of standards that were coeluted on a C column. The elution order of the standards on the two columns was sufficiently different, with a correlation coefficient between retention times on the C and XAmide columns of 0.0126, indicating good column orthogonality. Therefore, the first-dimension preparation was performed on a C column, followed by a XAmide column that was used to separate the fractions in the second dimension. Fifty-four fractions were prepared in the first dimension, with 25 fractions rich in saponins. Eight saponins, including two pairs of isomeric saponins and one new saponin, were isolated and identified from three representative fractions. This procedure was shown to be an effective approach for the preparative isolation and purification of saponins from leaves of P. notoginseng. Moreover, this method could possibly be employed in the purification of low-content and novel active saponins from natural products. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]

Eight new acidochromic dyes have been synthesised that can be used for optically monitoring pH in the range from 3 to 12. Their corresponding p K a values have been both measured and calculated theoretically by means of density functional theory. The synthesis of these new dyes is facile without the need for chromatographic purification. The dyes can be covalently linked to polymers containing hydroxyl functions such as cellulose, polyurethane hydrogel, and hydroxyalkyl methacrylate. The resulting sensor layers exhibit significant colour changes both in the UV and in the visible spectral range. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]

Characterization of humic substances (HS) in environmental samples generally involves labor-intensive and time-consuming isolation and purification procedures. In this paper, the development of an automated system for HS isolation and purification is described. The novelty of the developed system lies in the way the multiple liquids and columns used in the isolation/purification procedure are handled in both forward and back-elution mode by solenoid valves. The automated procedure significantly reduces the total throughput time needed, from 6–7 days to 48 h, and the amount of labor to obtain purified HS for further characterization. Chemical characterization of purified HS showed that results were in good agreement with previously published values for HS from a variety of sources, including the IHSS standard HS collection. It was also shown that the general properties of HS were consistent among the different source materials (soil, waste, aquatic) used in this study. The developed system greatly facilitates isolation and characterization of HS and reduces the risk of potential (time-dependent) alteration of HS properties in the manual procedure. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]

Purification methods for proteomics samples are of crucial concern for improving the quality of the sample delivered to the mass spectrometer. They constitute the link between the mass spectrometer and protein processing and peptide isolation steps that usually require solvents, buffers, or detergents completely incompatible with MS-analysis conditions. This work describes three new clean-up procedures using synthetic membranes and polymer media and compares them with standard procedures. The efficiency of each of the purification procedures was studied via application to four standards and two membrane proteins. This work highlights the importance of versatility in sample preparation, especially for MS-based proteomic investigations. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]

Three hundred and thirty two bacterial colonies were isolated from soil contaminated by an oil spill. All the bacteria were cultured in a liquid medium individually, and the surface tensions of the media were compared. The bacterium whose culture medium had the lowest surface tension was identified as Pseudomonas sp. G11. A biosurfactant was produced by cultivation of the Pseudomonas sp. G11 in the LB media. For extraction of the biosurfactant, two solvent systems were used ( n-hexane and a 2:1 (v/v) mixture of chloroform/MeOH), and the results were compared. Various experimental conditions (solvent composition, flow rate, etc.) were tested to optimize the analysis of the biosurfactant by asymmetrical flow field-flow fractionation (AsFlFFF). The biosurfactant was successfully separated from the culture medium by AsFlFFF when pure water was used as the carrier. From the retention data, the hydrodynamic diameter ( d H) and molecular weight ( M) of the biosurfactant were determined by AsFlFFF. The molecular weight was determined by using pullulans as the calibration standards. The d H and M were 49 nm and 2.3 × 105 Da when extracted with n-hexane, and 39 nm and 1.13 × 105 Da when extracted with the 2:1 mixture of chloroform/MeOH, respectively. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]