Search

Capillary electrophoresis (CE) has been investigated for the analysis of some neurotransmitters, dopamine (DA), 3-methoxytyramine (3-MT) and serotonin (5-hydroxytryptamine, 5-HT) at nanomolar concentrations in urine. Field-amplified sample injection (FASI) has been used to improve the sensitivity through the online pre-concentration samples. The cationic analytes were stacked at the capillary inlet between a zone of low conductivity - sample and pre-injection plug - and a zone of high conductivity - running buffer. Several FASI parameters have been optimized (ionic strength of the running buffer, concentration of the sample protonation agent, composition of the sample solvent and nature of the pre-injection plug). Best results were obtained using H(3)PO(4)-LiOH (pH 4, ionic strength of 80 mmol L(-1)) as running buffer, 100 μmol L(-1) of H(3)PO(4) in methanol-water 90/10 (v/v) as sample solvent and 100 μmol L(-1) of H(3)PO(4) in water for the pre-injection plug. In these conditions, the linearity was verified in the 50-300 nmol L(-1) concentration range for DA, 3-MT and 5-HT with a determination coefficient (r(2)) higher than 0.99. The limits of quantification (10 nmol L(-1) for DA and 3-MT, 5.9 nmol L(-1) for 5-HT) were 500 times lower than those obtained with hydrodynamic injection. However, if this method is applied to the analysis of neurotransmitters in urine, the presence of salts in the matrix greatly reduces the sensitivity of the FASI/CE-UV method.Therefore, a solid phase extraction (SPE) on a dedicated imprinted polymer (MIP) was developed to extract specific neurotransmitters, catecholamines, metanephrines and indolamines, from urine. Matrix salts were thus discarded after sample extraction on AFFINIMIP™ Catecholamine & Metanephrine (100mg) cartridge. Therefore, lower limits of quantification were determined in artificial urine (46 nmol L(-1) for DA, 11 nmol L(-1) for 3-MT and 6 nmol L(-1) for 5-HT).The application of this protocol MIP-SPE/FASI-CE-UV analysis of neurotransmitters in human urine gave rise to electropherograms with a very good base line and signal to noise ratios above 15.

The application of a tissue-based biosensor for the measurement of the concentration of catecholamines and indolamines is described. The bioelement of the biosensor is a rat liver section and the reaction of the deamination of biogenic amines (monoamineoxidase) was used. The concentration of NH + 4 was measured by using ah ammonium-selective electrode. The biosensor was used for measuring tyramine, dopamine, tryptamine and serotonin in the range ca. 10 −3 –10 −4 M; the lifetime of the biosensor is about 20–25 days. Optimization of the parameters of the biosensor is discussed.

This paper tackles a simple and efficient method for the simultaneous separation and stacking of neurotransmitters in capillary electrophoresis with UV detection. By using poly(diallyldimethylammonium chloride) (PDDAC) as a buffer additive, the high and reversed EOF are observed. Moreover, the mobility of indolamines and catecholamines decreases as the PDDAC concentration increases. Based on the difference in mobility in the presence and absence of PDDAC, the analytes were simply stacked between the boundary of the sample zone and the background electrolyte containing PDDAC. The separation of 14 analytes including indolamines, catecholamines, and metanephrines was accomplished within 33 min under optimal conditions (1.2% PDDAC and 5 mM formic acid at pH 4.0), and the values of relative standard deviation of their migration time were less than 3.1%. By applying stacking methods for fourteen analytes, we observed: (a) the sample injection volume of sample is up to 216 nL, (b) the limits of detection at signal-to-noise of 3 range from 15.4 to 122.1 nM, and (c) the sensitivity enhancements, compared to normal injection (12 nL), range from 110- to 220-fold. Under the optimal stacking conditions, the present method has been applied to analyze of vanillomandelic acid, 5-hydroxyindole-3-acetic acid, dopamine, tryptamine, and 3-indoxyl sulfate in urine samples.