Search

Raman spectral features of chromite, ulvospinel, magnetite, ilmenite, hematite, and some of their solid solutions are presented. Although most Fe-Ti-Cr-oxides produce relatively weak Raman signals compared to oxyanionic minerals, sufficient information can be extracted from their spectra to identify the end-member mineral phases as well as some information about compositional variations in solid solutions. Correlations between Raman spectral features and mineral chemistry are used to interpret the Raman data of Fe-Ti-Cr oxides found during Raman point-count measurements on rock chips of Martian meteorite EETA79001, as an analog to Mars on-surface planetary investigations. In general, ulvospinel, magnetite, and chromite end-members are readily distinguished by their Raman spectral patterns, as are ilmenite and hematite. In the low signal-to-noise (S/N) spectra generally obtained from the Raman point-count procedure, the position and shape of the strongest peak of Fe-Ti-Cr oxides in the region 660–680 cm−1 (A1g mode) is the most useful for discriminating Fe3+-Ti-Cr-Al substitutions in the magnetite-ulvospinel, ulvospinel-chromite, and chromite-spinel series, but minor peaks in the range 300–600 cm−1 also assist in discrimination. These spectral features are useful for investigating the variability among Fe-Ti-Cr-Al oxide solid solutions in natural samples. In EETA79001, a Martian basaltic meteorite, most of the oxide grains (as measured with the electron microprobe) are ulvospinel, chromian ulvospinel, and chromite, but ilmenite, titanian chromite, and titanomagnetite are also observed. The Fe-Ti-Cr-oxides identified by Raman point-count include end-member ilmenite, low-Al chromite-spinel solid solutions, ulvospinel-magnetite solid solutions, and more complex chromite-spinel-ulvospinel-magnetite solid solutions; the latter exhibit a wide range of main peak positions and broadened peak widths that may reflect structural disorder as well One Raman spectrum suggests end-member magnetite, and one spectrum from a different rock chip appears to be that of non-terrestrial hematite, reflecting local oxidizing alteration, which has not been observed previously in this meteorite. These results show that analyses done in an automated mode on the surface of an unprepared Martian rock sample can provide useful constraints on the Fe-Ti-Cr oxide mineralogy present and on compositional variations within those minerals, including an indication of oxygen fugacity.

This study reports the use of Raman spectral features to characterize the structural and compositional characteristics of different types of pyroxene from rocks as might be carried out using a portable field spectrometer or by planetary on-surface exploration. Samples studied include lunar rocks, martian meteorites, and terrestrial rocks. The major structural types of quadrilateral pyroxene can be identified using their Raman spectral pattern and peak positions. Values of Mg/(Mg + Fe + Ca) of pyroxene in the (Mg, Fe, Ca) quadrilateral can be determined within an accuracy of ± 0.1. The precision for Ca/(Mg + Fe + Ca) values derived from Raman data is about the same, except that corrections must be made for very low-Ca and very high-Ca samples. Pyroxenes from basalts can be distinguished from those in plutonic equivalents from the distribution of their Mg ′ [Mg/(Mg + Fe)] and Wo values, and this can be readily done using point-counting Raman measurements on unprepared rock samples. The correlation of Raman peak positions and spectral pattern provides criteria to distinguish pyroxenes with high proportions of non-quadrilateral components from (Mg, Fe, Ca) quadrilateral pyroxenes.