Search

There are the results of the electrical energy consumption research in a residential apartment building which is located in the Moscow region. Authors have given the information of the apartment electricity consumption with two people living. Research period is 2018 - 2022. Researchers have considered the main sources of electrical energy consumption in a typical apartment and in common property in this paper. It has been determinated the part of the considered apartment electrical energy consumption in the total consumption of electrical energy in an apartment building by authors of this paper. Researchers presented the information of the electric energy cost changes for the research period in the territory where were built considered building. It has been described the view and technical characteristics of the building by authors in this paper. There is the information of energy consumption in the cold, warm and transitional periods of the year. This work could be useful for companies which are in the field of managing common property, specialists from various areas of the municipal service complex, as well as developers who plan investments to residential construction in the Moscow region and other regions of the Russian Federation with similar climatic characteristics. This article is also could be used for the urban planning policy development in the field of providing electrical energy to settlements with a population less than 100 000 people. [ABSTRACT FROM AUTHOR]

Taking advantage of the potential of daylighting in the building helps to save energy used for artificial lighting. In Russia and other countries, where most of the energy is consumed for heating in winter, the increased window area leads to a reduction in the energy costs of artificial lighting but increases the heat loss through the windows blocks. Some studies contain criteria for assessing the feasibility of increasing the area of window, however, the influence of artificial light sources have not included. In this paper, the thermal balance of the room is considered, including the influence of artificial light sources, heat gain from solar radiation and transmission heat loss through window blocks. By calculating the difference in the thermal balance of the room after and before the increase in the window area, an expression of the criterion for evaluating the benefits of increasing the window area by energy indicators was obtained. Based on the cost of heat and electricity, the expression of the criterion for assessing the benefits of economic indicators was proposed. According to the presented criteria, the calculation for different function spaces: residential, office and school classes designed for Moscow was carried out. It is shown that, according to energy indicators, an increase in the window area is unprofitable or low profitable for residential and office premises, but beneficial for the school class. In conclusion, the paper shows the possibility of evaluating the energy efficiency of increasing the area of the window using the developed criteria. [ABSTRACT FROM AUTHOR]

This article is concerned with the problem of the development of renewable energy in the world. The paper presents the efficient potential of solar and geothermal energy in Russia. The advantages of using renewable energy technologies in buildings are presented. Examples of the introduction of renewable power plants into the building envelope are considered. A comparative analysis of the efficiency of solar facade power plants with thin-film panels is given on the example of a three-story residential building in two cities of Russia. The methods of regulation of state policy in relation to renewable energy in a number of countries are considered. The article provides comparable data on the percent of renewable energy sources in the total energy balance of European Union and Russia. [ABSTRACT FROM AUTHOR]

Following the energy strategy until 2035 of the Russian Federation, obsolete generation facilities are replaced with new promising combined-cycle power units with higher energy efficiency indicators. The difficulties of operating combined-cycle power units, particularly gas turbine units, are primarily related to the working fluid preparation quality. This article discusses the elaborate practice of the air supplied to the compressor, including its cooling and filtration. The paper presents an engineering solution for the technical re-equipment of an integrated air purifier by installing panels for the air's evaporative cooling. The porous structure of the panel material also allows for air filtration. The article presents the dependence of the power of a gas turbine installation on the temperature of the outdoor air in the climatic conditions of the Republic of Tatarstan (Russia). The economic effect of introducing the proposed technology is calculated, which is associated with eliminating lost profits from the under-development of electric energy and the quality of preparation of the working fluid for a gas turbine installation. [ABSTRACT FROM AUTHOR]

The article studies the topic of oil-containing wastes generated in oil production and refining and having a significant negative impact on the environment. The problem is that only a small amount of oil-containing wastes is currently processed with the help of technologies. To prevent environmental pollution and threats to public health, enterprises need to take measures to neutralize and reduce the hazard class of oily waste for oil storage facilities and distribution depots. The paper presents the case of terminal sludge collectors in Arkhangelsk, situated in the northern part of the Russian Federation. The authors give the rationale for reducing the hazard class of oil-containing wastes, slurry cards stored for long periods at the Arkhangelsk oil transshipment complex. A technology for lowering the hazardous class of oily waste is suggested. It includes several stages and implies the division of oil sludge into layers and splitting the treatment process into phases. The waste disposal treatment consists of dosage, heating, mixing of the solid phase of the waste with organic substances, preparation and heat treatment of mixtures. The application of the method allows for the neutralization and cure of oil-contaminated materials with optimal energy consumption and the use of domestic commercially available equipment. [ABSTRACT FROM AUTHOR]