Search

Li0.95Na0.05Ti2(PO4)3/C nanocomposite was prepared by sol-gel method.The structure and morphology of the samples were characterized by XRD, SEM which showed the particles had typical NASICON structure and diameter range from 400~500nm. The electrochemical performance were tested by cyclic voltammetry and galvanostatic charge–discharge. Results show Li0.95Na0.05Ti2(PO4)3/C nanocomposite exhibitsmuch better electrochemical performance than bare Li0.95Na0.05Ti2(PO4)3.

In order to develop a new technology for separating the bloedite by the method of gas hydrate formation, the phase equilibrium of the H2O-Na2SO4-MgSO4-C3H8 system and its subsystems was studied at 0℃ and pressure.The equilibrium pressure and the composition of solid and liquid above system were investigated.It was found that equilibrium pressure of gas hydrate formation was increasing with the increase of the Na2SO4( or MgSO4) concentration. The addition of anionic surfactant SDS helped to lower the equilibrium pressure of gas hydrate formation. The mother liquor amount entrained in the gas hydrate after liquid separation by sinking was very high when surfactants was not added. But the equilibrium pressure of gas hydrate formation and the mother liquor amount entrained in gas hydrate were decreased when surfactant was added to the system.

The phase equilibrium of the quaternary system H2O-H2O2-CO(NH2)2-C3H8 with gas hydrate formation had been studied at high pressure and low temperature. The temperature and pressure of gas hydrate formed from different hydrogen peroxide concentration aqueous were determined at adding surfactants and no surfactants separately. It was concluded that the equilibrium pressure of gas hydrate formation was increasing with the increase of the hydrogen peroxide concentration, the urea concentration and the temperature, the mother liquor amount entrained in the gas hydrate after liquid separation by sinking was very high when surfactants was not added, but the equilibrium pressure of gas hydrate formation was decreased and the mother liquor amount entrained in gas hydrate was also decreased when surfactants was added to the system. In addition, the equilibrium pressure of gas hydrate formation in the quaternary system H2O-H2O2-CO(NH2)2-C3H8 was calculated according to Chen-Guo thermodynamic model, improved UNIFAC mathematical equation and Aasberg-Peterson fugacity coefficient model. The calculated data was in agreement with the experiment data.

This template explains and demonstrates how to prepare your camera-ready paper for Trans Tech Publications. The best is to read these instructions and follow the outline of this text. Common and cheap organic matters (Glucose anhydrous, Citric acid, Vitamin C, Sucrose) were selected for carbon coatings on LiFePO4. The four pre-treatment processes were employed to optimize the carbon coating process, and through solid state-carbothermal reduction synthesis of LiFePO4/C composites. The structure, morphology and electrochemical performance of the material were studied by XRD, SEM and galvanostatic charge-discharge methods. It is observed that the tap density of citric acid coating material can reach 1.44 g/ml. Conductivity increased four orders of magnitude. At room temperature, the initial discharge specific capacity of the materials is as high as 89.6 mAh/g at 5.0 C (corresponding to 850 mA/g). After 30 cycles, the capacity is 83.9 mAh/g and decay only 2.0 %.