Search

Gentamicin sulfate is a potent broad spectrum aminoglycoside antibiotic which is used against Gram- positive and Gram-negative bacteria. A simple, isocratic HPLC method for separation, identification and determination of gentamicin and parabens (methylparaben and propylparaben) was developed and validated. To our knowledge there is no report about simultaneous determination of those three ana- lytes in pharmaceutical products. The optimum chromatographic conditions were achieved on CN column with a mobile phase consisting of 0.15% triethylamine in 10 mM KH 2 PO4 aqueous solution (final pH 3.0 adjusted with H 3 PO 4 ) and methanol in the ratio 70:30 (v/v), providing selective quan- tification of analytes within 5 min. The method was successfully validated according to ICH guidelines acceptance criteria in terms of selectivity, linearity, accuracy, precision and robustness. The linearity of the method was proved in defined concentrations ranges for gentamicin (0.32–1.04 mg mL1 ), meth- ylparaben (0.0072–0.0234 mg mL1 ) and propylparaben (0.0008–0.0026 mg mL1 ). Relative standard deviations calculated for all analytes in precision testing were <2% (analysis repeatability) and <3% (intermediate precision). Recovery values were between 98.87% and 101.67%. Chromatographic pa- rameters are not significantly influenced by small variations of column temperature, pH and molarity of KH2 PO 4 . Finally, the method was successfully applied for quantitative determination of gentamicin and parabens in commercially available solution for injection. Proposed HPLC method is found to be promising in terms of simplicity, analysis times and non-use of derivatization and ion-pair agents.

A simple and convenient reversed-phase high-performance liquid chromatography (RP-HPLC) method for simultaneous separation, identification, and determination of sodium metabisulfite and sodium benzoate in pharmaceutical formulation has been developed and validated. Chromatographic separation was achieved on RP column Zorbax Extend C-18 (150 x 4.6 mm i.d., 3.5 mu m particles), and mixture of 0.1% phosphoric acid and acetonitrile in the ratio 62: 38 (v/v) was used as a mobile phase. The flow rate was set at 1.0 mL/min with detection wavelength of 275 nm. The method was successfully validated according to International Conference on Harmonization (ICH) guidelines acceptance criteria. The method is selective, as no interferences were observed at retention times corresponding to these analytes. Results of regression analyses (r) and statistical insignificance of calibration curve intercepts (p) proved linearity of the method in defined concentration ranges for sodium metabisulfite and sodium benzoate (0.05-0.15 mg/mL). Relative standard deviations calculated for both analytes in precision testing were below the limits defined for active pharmaceutical ingredients (analysis repeatability: lt 2%; intermediate precision: lt 3%). Recovery values were between 98.16% and 101.94%. According to results of robustness testing, chromatographic parameters are not significantly influenced by small variation of acetonitrile content in mobile phase, column temperature, and flow rate. Finally, the method was applied for quantitative determination of investigated preservatives in real sample analysis.