Search

The addition of nanoparticles has been presented as an alternative approach to counteract the degradation of polymeric solutions for enhanced oil recovery. In this context, a nanohybrid (NH34) of partially hydrolyzed polyacrylamide (MW ∼12 MDa) and nanosilica modified with 2% 3-aminopropyltriethoxysilane (nSiO 2 -APTES) was synthesized and evaluated. NH34 was characterized by using dynamic light scattering, Fourier-transform infrared spectroscopy, and thermogravimetric analysis. Fluid-fluid tests assessed its viscosifying power, mechanical stability, filterability, and emulsion behavior. Rock-fluid tests were carried out to determine the nanohybrid's adsorption in porous media, the inaccessible pore volume (IPV), and the resistance (RF) and residual resistance factors (RRF). These tests were conducted under the conditions of a Colombian field. NH34 results were compared with four (4) commercial polymers (P34, P88, P51, and PA2). The viscosifying power of NH34 was observed to be similar to that of the four commercial polymers at a lower concentration, but it exhibits more resistance to mechanical and chemical degradation. The evaluation of the emulsion behavior showed that the nanohybrid neither changed the dehydration process nor altered the crude oil viscosity, favoring its extraction at the wellhead. However, the water clarification treatment must be adjusted because the oil and grease contents and turbidity increase with the residual concentration of NH34. Incremental oil recovery factors obtained by numerical simulation (compared to waterflooding) were P51 (5.5%) > P34 (4.9%) > P88 (4.8%) > NH34 (2.6%) > PA2 (0.9%). The polymers P51, P34, and P88 had a better recovery factor than NH34 and PA2 due to their lower values of residual adsorption and IPV. Few studies have been reported on polymer nanohybrids' emulsion and flow behavior. Therefore, further research is needed to enhance our understanding of the fundamental enhanced oil recovery mechanisms associated with polymer nanohybrids., Competing Interests: The authors declare no competing financial interest., (© 2024 The Authors. Published by American Chemical Society.)

Nanoparticles (NPs) have been proposed as additives to improve the rheological properties of polymer solutions and reduce mechanical degradation. This study presents the results of the retention experiment and the numerical simulation of the displacement efficiency of a SiO 2 /hydrolyzed polyacrylamide (HPAM) nanohybrid (CSNH-AC). The CSNH-AC was obtained from SiO 2 NPs (synthesized by the Stöber method) chemically modified with HPAM chains. Attenuated total reflection-Fourier transform infrared spectroscopy, field emission gun-scanning electron microscopy, X-ray diffraction, and thermogravimetric analysis were used to characterize the nanohybrid. The injectivity and dynamic retention tests were performed at 56 °C in a sandstone core with a porosity of ∼26% and a permeability of 117 and 287 mD. A history matching of the dynamic retention test was performed to determine the maximum and residual adsorption, IPV, and residual resistance factor (RRF). A laboratory-scale model was used to evaluate the displacement efficiency of CSNH-AC and HPAM through numerical simulation. According to the results, the nanohybrid exhibits better rheological behavior than the HPAM solution at a lower concentration. The nanopolymer sol adsorption and IPV (29,7 μg/g rock , 14,5) are greater than those of the HPAM solution (9,2 μg/g rock , 10), which was attributed to the difference between the rock permeabilities used in the laboratory tests (HPAM: 287 mD and CSNH-AC: 117 mD). The RF of both samples gradually increases with the increase in shear rate, while the RRF slightly decreases and tends to balance. However, the nanopolymer sol exhibits greater RF and RRF values than that of the polymer solution due to the strong flow resistance of the nanohybrid (higher retention in the porous media). According to the field-scale simulation, the incremental oil production could be 295,505 and 174,465 barrels for the nanopolymer sol and the HPAM solution, respectively (compared to waterflooding). This will represent an incremental recovery factor of 11.3% for the nanopolymer sol and 6.7% for the HPAM solution., Competing Interests: The authors declare no competing financial interest., (© 2024 The Authors. Published by American Chemical Society.)