Search

Robust, nanoscale light-emitting devices are attractive for emerging photonic and quantum engineering applications. However, conventional approaches suffer from fabrication challenges or lack the potential to address individual nanostructures, such as quantum dots. In this paper, we present a device that can produce electrically driven light emission from a single quantum dot using a single carbon nanotube as the charge injection contact. The device has a metal-oxide-semiconductor capacitor structure and operates based on an unconventional mechanism of electroluminescence, which relies on the use of bipolar voltage pulses. The proposed device can be fabricated in a simple manner using conventional lithographic processes, offering a scalable approach toward the development of optoelectronic devices at the single dot level.

Robust, nanoscale light-emitting devices are attractive for emerging photonic and quantum engineering applications. However, conventional approaches suffer from fabrication challenges or lack the potential to address individual nanostructures, such as quantum dots. In this paper, we present a device that can produce electrically driven light emission from a single quantum dot using a single carbon nanotube as the charge injection contact. The device has a metal-oxide-semiconductor capacitor structure and operates based on an unconventional mechanism of electroluminescence, which relies on the use of bipolar voltage pulses. The proposed device can be fabricated in a simple manner using conventional lithographic processes, offering a scalable approach toward the development of optoelectronic devices at the single dot level.

Inverse Compton Scattering (ICS) is an emerging compact X-ray source technology, where the small source size and high spectral brightness are of interest for multitude of applications. However, to satisfy the practical flux requirements, a high-repetition-rate ICS system needs to be developed. To this end, this paper reports the experimental demonstration of a high peak brightness ICS source operating in a burst mode at 40 MHz. A pulse train interaction has been achieved by recirculating a picosecond CO2 laser pulse inside an active optical cavity synchronized to the electron beam. The pulse train ICS performance has been characterized at 5- and 15- pulses per train and compared to a single pulse operation under the same operating conditions. With the observed near-linear X-ray photon yield gain due to recirculation, as well as noticeably higher operational reliability, the burst-mode ICS offers a great potential for practical scalability towards high duty cycles.

© 2016 AIP Publishing LLC. We demonstrate broad bandwidth and intense sub-100 eV high-order harmonics from diatomic carbon molecules driven by long-wavelength laser pulses. Up to now, one limitation of the intense carbon harmonic source driven by a 0.8 μm wavelength Ti:sapphire laser has been the low cutoff around ∼32 eV. In this paper, we show that this harmonic cutoff is extended to ∼70 eV by increasing the driving laser wavelength to 1.71 μm. Surprisingly, the carbon harmonic intensity is found to be high despite the long wavelength driving laser. Experiments show only ∼30% decrease in the harmonic intensity when changing the driving laser wavelength from 0.8 μm to 1.71 μm. Such intense sub-100 eV coherent X-rays would have important applications in various domains of science and technology.

With the growing prominence of wearable electronic technology, there is a need to improve the mechanical reliability of electronics for more demanding applications. Conductive wires represent a vital component present in all electronics. Unlike traditional planar and rigid electronics, these new wearable electrical components must conform to curvilinear surfaces, stretch with the body, and remain unobtrusive and low profile. In this paper, the piezoresistive response of shrink induced wrinkled gold thin films under strain demonstrates robust conductive performance in excess of 200% strain. Importantly, the wrinkled metallic thin films displayed negligible change in resistance of up to 100% strain. The wrinkled metallic wires exhibited consistent performance after repetitive strain. Importantly, these wrinkled thin films are inexpensive to fabricate and are compatible with roll to roll manufacturing processes. We propose that these wrinkled metal thin film wires are an attractive alternative to conventional wires for wearable applications.