Search

The stress state is critical to the reliability of structures, but existing ultrasonic methods are challenging to measure local stress. In this paper, zero-group-velocity (ZGV) Lamb mode was proposed to measure the local stress field in thin aluminum plates. The Lamb wave’s dispersive characteristics under initial stress were analyzed based on the Floquet-Bloch theory with Murnaghan hyperelastic material model. The obtained dispersion curves show that higher-order Lamb wave modes near the cut-off frequencies are sensitive to applied stress across the plate, indicating that the S1-ZGV mode has a rather high sensitivity to stress. Similar to conventional ultrasonic stress measurement, it is found that the frequency of the S1-ZGV mode changes near-linearly with the amplitude of applied stress. Numerical experiments were conducted to illustrate the feasibility of local stress measurement in a thin aluminum plate based on the S1-ZGV mode. Single and multiple localized stress fields were evaluated with the S1-ZGV method, and reconstructed results matched well with actual stress fields, proving that the ZGV Lamb wave method is a sensitive stress measurement technique in thin plates.

Defect inspection of braided carbon fiber reinforced polymer (CFRP) is very difficult due to its nonhomogeneity, anisotropy, and sensitivity to coupling agents. This paper presents a hybrid system for detecting microstructure and defects in braided CFRP that combines the advantages of laser-ultrasound and air-coupled ultrasonic testing. Through the finite element method, the ultrasonic field propagating on the braided CFRP was simulated during the laser-induced ultrasound, and the influences of laser parameters and surface braided structure were analyzed on the laser ultrasonic signal. This detection method based on air-coupled laser ultrasound can provide the near-surface microstructure characterization of the resin pockets and braided fiber bundles, and also can achieve both shallow and deep defect detection of CFRP sheets which is comparable to that of the contact-type high-frequency phased array with higher contrast and less distortion. These results indicate that it has the potential to develop a non-contact, high-resolution, and low-cost method for the detection and repairment of advanced composite materials.