Search

Modulating the electronic structure of the electrocatalyst plays a vital role in boosting the electrocatalytic performance of the oxygen evolution reaction (OER). In this work, we introduced a one-step solvothermal method to fabricate 1,1-ferrocene dicarboxylic acid (FcDA)-decorated self-evolved nickel sulfide (Ni3S2) nanosheet arrays on a nickel foam (NF) framework (denoted as FcDA-Ni3S2/NF). Benefiting from the interconnected ultrathin nanosheet architecture, ligand dopants induced and facilitated in situ structural reconstruction, and the FcDA-decorated Ni3S2(FcDA-Ni3S2/NF) outperformed its singly doped and undoped counterparts in terms of OER activity. The optimized FcDA-Ni3S2/NF self-supported electrode presents a remarkably low overpotential of 268 mV to achieve a current density of 10 mA cm–2for the OER and demonstrates robust electrochemical stability for 48 h in a 1.0 M KOH electrolyte. More importantly, in situ electrochemical Raman spectroscopy reveals the generation of catalytically active oxyhydroxide species (NiOOH) derived from the surface construction during the OER of pristine FcDA-Ni3S2/NF, contributing significantly to its superior electrocatalytic performance. This study concerns the modulation of electronic structure through ligand engineering and may provide profound insight into the design of cost-efficient OER electrocatalysts.

In our previous work (Yang et al. Anal. Chem.2018, 90(5), 3307−3312), we reported that a large diameter Nafion dryer can be used in the PERCA (PEroxy Radical Chemical Amplification) technique to minimize the impact of water vapor on the chain length (CL). By using a Nafion dryer, the sample was first dried to a low relative humidity (RH) and was then drawn into a FEP (fluorinated ethylene propylene) flow reactor tube to start the amplification cycles for peroxy radical measurement. This method provides a promising and simple method to minimize the sensitivity of CL to water vapor. However, there is a trade-off between inlet radical losses and moisture removal efficiency under high ambient RH conditions. In this paper, we report a further improvement by removing the inlet Nafion dryer and using it directly as an amplifier. The sample was drawn into the Nafion dryer directly without preconditioning to reduce inlet losses; the amplification and HO2reformation cycles were started in the Nafion dryer. The CL value at 3% RHinletwas about 150. A linear relationship between CL and RHinletup to 87% RH was observed. Low loss of the CL under high RHinlet(about 10% reduction at 87% RH) was achieved. As a result, the modified system can largely remove the uncertainty of the CL arising from water vapor under most ambient conditions.