Search

Abstract: This work describes a practical way to optimize the high level of the chef creativity to produce rational approaches to food design. It is particularly focused on the preparation of two dishes: bubbly juice and false skin. For the first dish, three samples were prepared with egg white protein (EWP) and xanthan gum at pH 4.6 and pH 7.0. At pH 4.6 (isoelectric point), there were substantial differences of the interfacial dilational modulus of EWP when xanthan gum was added. At 1 mg/ml xanthan, the system showed a very strong interface (high viscoelasticity) compared to the other samples. Measuring half drainage time revealed which samples were the most stable. The properties discussed were related to stability. For the false skin dish, edible films were made by gelatin extracted from cod skins (A solution) and a mixture of cod skin gelatin and commercial gelatin (AG solution). The results showed that tensile strength (TS) of gelatin films increases almost by 25%, elongation at break (EAB) by 14%, and the Young modulus (E) by almost 100% when increasing protein concentration. To confirm water plasticizer effect, the results were compared to a gelatin film made with 30% glycerol (plasticizer). Water content affects to a great extent the mechanical properties of the films. Finally, images of the dishes are presented in order to have a full view of the purpose and the results obtained.

In order to understand the mechanisms behind the undesired aging of films based on vital wheat gluten plasticized with glycerol, films cast from water/ethanol solutions were investigated. The effect of pH was studied by casting from solutions at pH 4 and pH 11. The films were aged for 120 days at 50% relative humidity and 23 °C, and the tensile properties and oxygen and water vapor permeabilities were measured as a function of aging time. The changes in the protein structure were determined by infrared spectroscopy and size-exclusion and reverse-phase high-performance liquid chromatography, and the film structure was revealed by optical and scanning electron microscopy. The pH 11 film was mechanically more stable with time than the pH 4 film, the latter being initially very ductile but turning brittle toward the end of the aging period. The protein solubility and infrared spectroscopy measurements indicated that the protein structure of the pH 4 film was initially significantly less polymerized/aggregated than that of the pH 11 film. The polymerization of the pH 4 film increased during storage but it did not reach the degree of aggregation of the pH 11 film. Reverse-phase chromatography indicated that the pH 11 films were to some extent deamidated and that this increased with aging. At the same time a large fraction of the aged pH 11 film was unaffected by reducing agents, suggesting that a time-induced isopeptide cross-linking had occurred. This isopeptide formation did not, however, change the overall degree of aggregation and consequently the mechanical properties of the film. During aging, the pH 4 films lost more mass than the pH 11 films mainly due to migration of glycerol but also due to some loss of volatile mass. Scanning electron and optical microscopy showed that the pH 11 film was more uniform in thickness and that the film structure was more homogeneous than that of the pH 4 film. The oxygen permeability was also lower for the pH 11 film. The fact that the pH 4 film experienced a larger and more rapid change in its mechanical properties with time than the pH 11 film, as a consequence of a greater loss of plasticizer, was presumably due to its initial lower degree of protein aggregation/polymerization. Consequently, the cross-link density achieved at pH 4 was too low to effectively retain volatiles and glycerol within the matrix.

High hydrostatic pressure is a well-known non-thermal technology used for food pasteurization. However, this technology can be applied to purposes beyond microbial inactivation. This work is focused on the effect of high hydrostatic pressure on yield and texture of fresh foie grasfor gastronomical purposes. The impact of production method of the raw material and the effects of pressure intensity and holding time are discussed based on sensory tests after expert cooking and the evidence of structural modifications in product (texture and fat loss). The attained results indicate that high pressure processing can be used, not only to extend the preservation of the product, but also to improve the texture and to increase the yield of high-quality foie gras, by decreasing fat loss during cooking. Our results evidence a more homogeneous and better behaviour of the pressurized product, with a firmer consistency and up to a 33% if improvement in cooking yield compared to untreated samples.