Search

Background. Early diagnosis of sepsis is the key to timely, targeted treatment. Cell population data (CPD) has been widely used in many diseases, but its predictive value for early diagnosis and the clinical outcome of sepsis remains unclear. Therefore, this paper discusses whether peripheral blood leukocyte parameters can be used as predictive indicators for early diagnosis and the clinical outcome of sepsis. Methods. A retrospective study of 45 patients with sepsis, 53 patients with nonseptic infections, and 86 healthy check-ups admitted to Gansu Provincial Hospital from January 2021 to June 2022 was done using a hematology analyzer. Results. The results of LYMPH#, HFLC#, IG#, NE-WX, LY-WX, LY-WY, and MO-WX showed better diagnostic efficiency in the sepsis group and nonseptic infection group. When the seven differential leukocyte parameters were used to establish diagnostic models, the sensitivity and specificity were 82.20% and 77.40%, respectively. Correlation analysis showed that LYMPH# and HFLC# were positively correlated with PCT ( P < 0.05 ). The clinical outcome of sepsis showed that the leukocyte parameters of discharged WBC and LY-X had better predictive efficacy. When the two differential leukocyte parameters were used to establish diagnostic models, the sensitivity and specificity were 90.90% and 100.00%. Cox regression analysis showed that leukocyte parameters of discharged WBC and LY-X were independent predictors of clinical outcomes ( P < 0.05 ). Conclusion. Leucocyte parameters HFLC#, IG#, NE-WX, LY-WX, LY-WY, and MO-WX had a certain auxiliary effect on the early diagnosis of sepsis leukocyte parameters of discharged WBC and LY-X were independent predictors of clinical outcomes in patients with sepsis. Therefore, peripheral blood leukocyte parameters may have predictive value for early diagnosis and the clinical outcome of sepsis, but large-scale retrospective studies are still needed to prove our preliminary results.

High-quality all-inorganic perovskite CsPb(BrxI1-x)3 quantum dots (QDs) with quantum yield of 50% were systematically studied as yellow light convertor for light emitting diodes (LEDs). A novel heat insulation structure was designed for the QD-converted yellow LEDs. In this structure, a silicone layer was set on top of the GaN LED chip to prevent directly heating of the QDs by the LED chip. Then the CsPb(BrxI1-x)3 QDs were filled in the bowl-shaped silicone layer after ultrasonic dispersion treatment. Finally, an Al2O3 passivation layer was grown on the QDs layer by Atomic Layer Disposition at 40 °C. When x = 0.55, highly pure yellow LEDs with an emission peak at ∼570 nm and a full width at half maximum of 25 nm were achieved. The chromaticity coordinates of the QD-converted yellow LEDs (0.4920 ± 0.0017, 0.4988 ± 0.0053) showed almost no variation under driving current from 5 mA to 150 mA. During an operation period of 60 min, the emission wavelength of the yellow LEDs showed no distinct shift. Moreover, the luminous efficiency of the QD-converted yellow LEDs achieved 13.51 l m/W at 6 mA. These results demonstrated that CsPb(BrxI1-x)3 QDs and the heat insulation structure are promising candidate for high purity yellow LEDs.

A GaN/CH3NH3PbBr3 heterojunction was fabricated by depositing a GaN thin layer on a CH3NH3PbBr3 single crystal by plasma enhanced atomic layer deposition. The band alignment of the GaN/CH3NH3PbBr3 heterojunction was studied by x-ray photoelectron spectroscopy. The valance band offset (VBO) is directly determined to be 0.13 ± 0.08 eV. The conduction band offset is deduced from the VBO and the band gaps, which turned out to be 1.39 ± 0.12 eV. Thus, the band alignment of the GaN/CH3NH3PbBr3 heterojunction is determined to be type-I. These results show that GaN is a promising material for carrier confinement in halide perovskite based light emitting devices.