Search

© 2019 IEEE. In this paper, we introduce a probabilistic framework for INertial Lidar Localisation And MApping (IN2LAMA). Most of today's lidars are based on spinning mechanisms that do not capture snapshots of the environment. As a result, movement of the sensor can occur while scanning. Without a good estimation of this motion, the resulting point clouds might be distorted. In the lidar mapping literature, a constant velocity motion model is commonly assumed. This is an approximation that does not necessarily always hold. The key idea of the proposed framework is to exploit preintegrated measurements over upsampled inertial data to handle motion distortion without the need for any explicit motion-model. It tightly integrates inertial and lidar data in a batch on-manifold optimisation formulation. Using temporally precise upsampled preintegrated measurement allows frame-to-frame planar and edge features association. Moreover, features are re-computed when the estimate of the state changes, consolidating front-end and back-end interaction. We validate the effectiveness of the approach through simulated and real data.

Dense visual SLAM methods are able to estimate the 3D structure of an environment and locate the observer within them. They estimate the motion of a camera by matching visual information between consecutive frames, and are thus prone to failure under extreme motion conditions or when observing texture-poor regions. The integration of additional sensor modalities has shown great promise in improving the robustness and accuracy of such SLAM systems. In contrast to the popular use of inertial measurements we propose to tightly-couple a dense RGB-D SLAM system with kinematic and odometry measurements from a wheeled robot equipped with a manipulator. The system has real-time capability while running on GPU. It optimizes the camera pose by considering the geometric alignment of the map as well as kinematic and odometric data from the robot. Through experimentation in the real-world, we show that the system is more robust to challenging trajectories featuring fast and loopy motion than the equivalent system without the additional kinematic and odometric knowledge, whilst retaining comparable performance to the equivalent RGB-D only system on easy trajectories.

Soft robotic systems offer benefits over traditional rigid systems through reduced contact trauma with soft tissues and by enabling access through tortuous paths in minimally invasive surgery. However, the inherent deformability of soft robots places both a greater onus on accurate modelling of their shape, and greater challenges in realising intraoperative shape sensing. Herein we present a proprioceptive (self-sensing) soft actuator, with an electrically conductive working fluid. Electrical impedance measurements from up to six electrodes enabled tomographic reconstructions using Electrical Impedance Tomography (EIT). A new Frequency Division Multiplexed (FDM) EIT system was developed capable of measurements of 66 dB SNR with 20 ms temporal resolution. The concept was examined in two two-degree-of-freedom designs: a hydraulic hinged actuator and a pneumatic finger actuator with hydraulic beams. Both cases demonstrated that impedance measurements could be used to infer shape changes, and EIT images reconstructed during actuation showed distinct patterns with respect to each degree of freedom (DOF). Whilst there was some mechanical hysteresis observed, the repeatability of the measurements and resultant images was high. The results show the potential of FDM-EIT as a low-cost, low profile shape sensor in soft robots., Comment: Fixed PDF conversion error. Now published in ICRA 2019, IEEE International Conference on Robotics and Automation 2019