1. Objective Analysis of Pre-Lens Tear Film Stability of Daily Disposable Contact Lenses Using Ring Mire Projection
- Author
-
Marx S, Eckstein J, and Sickenberger W
- Subjects
non-invasive break-up time ,pre-lens tear film stability ,non-invasive drying-up time ,lcsh:Ophthalmology ,lcsh:RE1-994 ,daily disposable contact lenses ,wettability ,corneal topography - Abstract
Sebastian Marx,1 Julia Eckstein,1 Wolfgang Sickenberger1,2 1JENVIS Research c/o Ernst-Abbe University of Applied Sciences Jena, Jena, Germany; 2Department of Optometry & Vision Science, Ernst-Abbe University of Applied Sciences Jena, Jena, GermanyCorrespondence: Sebastian MarxJENVIS Research c/o Ernst-Abbe University of Applied Sciences Jena, Carl-Zeiss-Promenade 2, Jena 07745, GermanyEmail s.marx@jenvis-research.comPurpose: The primary objective of this study was to evaluate the in vivo pre-lens non-invasive drying-up time of two types of daily disposable contact lenses (DDCLs) after 12 hours of wear.Methods: This prospective, randomized, single-center, cross-over pilot study evaluated 31 subjects aged 18– 44 years with normal eyes and good tear film stability who were adapted current soft contact lens wearers. Subjects wore nelfilcon A and stenfilcon A DDCLs for 12 hours each on two different days. Non-invasive video keratography drying-up time (NIK-DUT) videos of each eye were recorded 12 hours after lens insertion for about 25 seconds, with a 5-minute tear film recovery time allowed between video recordings of the right and left eyes to avoid bias. Post-blink time required to reach 15% distortion of the projected rings and the speed of break-up at 15 seconds post-blink were measured at each time point and on-eye wettability was determined by ring mire projection under white light illumination.Results: Mean time to reach 15% ring distortion was similar for nelfilcon A (19.25± 3.20 sec) and stenfilcon A (20.24± 3.02 sec) DDCLs but varied highly among subjects. The mean speed of break-up at 15 sec post-blink was 0.3± 0.38% distortion/sec (95% confidence interval [CI] 0.138– 0.365% distortion/sec) for nelfilcon A and 0.2± 0.23% distortion/sec (95% CI 0.048– 0.279% distortion/sec) for stenfilcon A DDCLs.Conclusion: Multifunctional topography allowed the objective evaluation of in vivo pre-lens tear film stability using ring mire projection. This dynamic method was simple, fast and non-invasive, enabling measurements of NIK-DUT and evaluating wettability over a large area, greater than the optical zone of the contact lens surface, for the entire inter-blink interval.Keywords: pre-lens tear film stability, wettability, daily disposable contact lenses, non-invasive break-up time, non-invasive drying-up time, corneal topography
- Published
- 2020