Search

The synthesis of novel, renewable lignin-based protective films with anticorrosive properties is presented in this work. Thermosetting films are prepared by means of tandem UV-initiated thiol-yne "click" synthesis and Claisen rearrangement strategy. These films contain high lignin loading, 46-61%, originating from a nickel-catalyzed birch wood reductive catalytic fractionation (RCF) process. Lignin fractions with varying monomer content are compared before resins preparation, namely a mixture of monomers and oligomers without fractionation, or after fractionation via extraction and membrane separation. This study aims to determine if the separation of lignin monomers and oligomers is necessary for the application as a thermosetting resin. The resulting films exhibit remarkable adhesion to a metal surface and excellent solvent resistance, even after exposure to a corrosive environment. Moreover, those films show superior barrier properties, studied with odd random phase electrochemical impedance spectroscopy (ORP EIS). After 21 days of exposure, the examined films still show impressive high corrosion protection with the low-frequency impedance approximate to 10(10) omega cm(2) and capacitive behavior. This work demonstrates an interesting proof-of-concept where laborious, costly, and energy-intensive separation of the depolymerized lignin mixture of monomers and oligomers is not necessary for the successful resin synthesis with excellent properties using the applied synthetic strategy.

Depolymerization of cellulose is often used as a (pre)treatment protocol within the catalytic valorization strategies of cellulose. Typical depolymerization protocols yield polymerization degrees above 70 anhydroglucose units (AGU). However, shorter cellulose fibers are of interest in the search for accessible dietary fiber additives or renewable materials with distinct mechanical properties (bio-composites). In this work, short-polymer microcrystalline celluloses (SMCC) with an average polymerization degree between 29 and 70 AGU were produced with material yields of 95 % and above by combining a planetary ball mill pretreatment with mild acid hydrolysis. By first decreasing the levelling-off degree of polymerization (LODP) with an intensive ball mill treatment, a mild acid hydrolysis protocol was sufficient to ensure high yields of SMCC. Furthermore, the desired polymerization degree could be obtained by tuning the process parameters.