Search

This article presents the main results of the validation phase of the PRENOLIN project. PRENOLIN is an international benchmark on 1D nonlinear (NL) site-response analysis. This project involved 19 teams with 23 different codes tested. It was divided into two phases; with the first phase verifying the numerical solution of these codes on idealized soil profiles using simple signals and real seismic records. The second phase described in this article referred to code validation for the analysis of real instrumented sites. This validation phase was performed on two sites (KSRH10 and Sendai) of the Japanese strong-motion networks KiK-net and Port and Airport Research Institute (PARI), respectively, with a pair of accelerometers at surface and depth. Extensive additional site characterizations were performed at both sites involving in situ and laboratory measurements of the soil properties. At each site, sets of input motions were selected to represent different peak ground acceleration (PGA) and frequency content. It was found that the code-to-code variability given by the standard deviation of the computed surface-response spectra is around 0.1 (in log10 scale) regardless of the site and input motions. This indicates a quite large influence of the numerical methods on site-effect assessment and more generally on seismic hazard. Besides, it was observed that sitespecific measurements are of primary importance for defining the input data in siteresponse analysis. The NL parameters obtained from the laboratory measurements should be compared with curves coming from the literature. Finally, the lessons learned from this exercise are synthesized, resulting also in a few recommendations for future benchmarking studies, and the use of 1D NL, total stress site-response analysis. © 2018, Seismological Society of America. All rights reserved.

We simulate non-linear behaviour of soils during strong ground motion in the Rhône valley in southern Switzerland. Previous studies of the site response using weak ground motion, ambient noise and linear 3-D FD simulations suggest that the 2-D structure of the basin will lead to amplification factors of up to 12 in the frequency band between 0.5 and 10 Hz. To estimate the importance of non-linear soil behaviour during strong ground motion in the Rhône valley we simulate the response of a superficial soft layer with a fully non-linear 1-D finite difference code. The non-linear wave propagator is based on an effective stress constitutive soil model capable of predicting pore pressure evolution due to shear. We determine the required dilatancy parameters from laboratory analysis of soil samples using cyclic triaxial tests. In order to include the effect of the strong 2-D structure in our non-linear analysis synthetic seismograms are convolved with the transfer function of the basin and then propagated through a 1-D non-linear layer. We find that reduced amplification due to soil non-linearity can be expected at rock accelerations above 0.5 ms−2, and that de-amplification occurs at ground motion levels of approximately 2 ms−2. Nevertheless, the spectral accelerations simulated for the valley centre are still exceeding the design spectra at about 0.5 Hz for magnitudes above 6.0, which reflects the strong amplification of ground motion by the deep 2-D resonance of the basin. For frequencies above 1 Hz the design spectra are generally in agreement with the strongest simulated accelerations. We evaluate the occurrence of soil failure using the 5 per cent strain criterion as a function of hypocentral distance and magnitude. Results confirm observations of liquefaction reported after the 1855 Mw 6.4 earthquake of Visp, and they suggest that soil liquefaction may occur at distances beyond those predicted by empirical relations in the valley. Near the basin edge, however, the s

Ground motions of the 2011 Tohoku earthquake recorded at Onahama port (Iwaki, Fukushima prefecture) rank among the highest accelerations ever observed, with the peak amplitude of the 3-D acceleration vector approaching 2g. The response of the site was distinctively non-linear, as indicated by the presence of horizontal acceleration spikes which have been linked to cyclic mobility during similar observations. Compared to records of weak ground motions, the response of the site during the Mw 9.1 earthquake was characterized by increased amplification at frequencies above 10 Hz and in peak ground acceleration. This behaviour contrasts with the more common non-linear response encountered at non-liquefiable sites, which results in deamplification at higher frequencies. We simulate propagation of SH waves through the dense sand deposit using a non-linear finite difference code that is capable of modelling the development of excess pore water pressure. Dynamic soil parameters are calibrated using a direct search method that minimizes the difference between observed and simulated acceleration envelopes and response spectra. The finite difference simulations yield surface acceleration time-series that are consistent with the observations in shape and amplitude, pointing towards soil dilatancy as a likely explanation for the high-frequency pulses recorded at Onahama port. The simulations also suggest that the occurrence of high-frequency spikes coincided with a rapid increase in pore water pressure in the upper part of the sand deposit between 145 and 170 s. This sudden increase is possibly linked to a burst of high-frequency energy from a large slip patch below the Iwaki region

We simulate non-linear behaviour of soils during strong ground motion in the Rhône valley in southern Switzerland. Previous studies of the site response using weak ground motion, ambient noise and linear 3-D FD simulations suggest that the 2-D structure of the basin will lead to amplification factors of up to 12 in the frequency band between 0.5 and 10 Hz. To estimate the importance of non-linear soil behaviour during strong ground motion in the Rhône valley we simulate the response of a superficial soft layer with a fully non-linear 1-D finite difference code. The non-linear wave propagator is based on an effective stress constitutive soil model capable of predicting pore pressure evolution due to shear. We determine the required dilatancy parameters from laboratory analysis of soil samples using cyclic triaxial tests. In order to include the effect of the strong 2-D structure in our non-linear analysis synthetic seismograms are convolved with the transfer function of the basin and then propagated through a 1-D non-linear layer. We find that reduced amplification due to soil non-linearity can be expected at rock accelerations above 0.5 ms−2, and that de-amplification occurs at ground motion levels of approximately 2 ms−2. Nevertheless, the spectral accelerations simulated for the valley centre are still exceeding the design spectra at about 0.5 Hz for magnitudes above 6.0, which reflects the strong amplification of ground motion by the deep 2-D resonance of the basin. For frequencies above 1 Hz the design spectra are generally in agreement with the strongest simulated accelerations. We evaluate the occurrence of soil failure using the 5 per cent strain criterion as a function of hypocentral distance and magnitude. Results confirm observations of liquefaction reported after the 1855 Mw 6.4 earthquake of Visp, and they suggest that soil liquefaction may occur at distances beyond those predicted by empirical relations in the valley. Near the basin edge, however, the s

Ground motions of the 2011 Tohoku earthquake recorded at Onahama port (Iwaki, Fukushima prefecture) rank among the highest accelerations ever observed, with the peak amplitude of the 3-D acceleration vector approaching 2g. The response of the site was distinctively non-linear, as indicated by the presence of horizontal acceleration spikes which have been linked to cyclic mobility during similar observations. Compared to records of weak ground motions, the response of the site during the Mw 9.1 earthquake was characterized by increased amplification at frequencies above 10 Hz and in peak ground acceleration. This behaviour contrasts with the more common non-linear response encountered at non-liquefiable sites, which results in deamplification at higher frequencies. We simulate propagation of SH waves through the dense sand deposit using a non-linear finite difference code that is capable of modelling the development of excess pore water pressure. Dynamic soil parameters are calibrated using a direct search method that minimizes the difference between observed and simulated acceleration envelopes and response spectra. The finite difference simulations yield surface acceleration time-series that are consistent with the observations in shape and amplitude, pointing towards soil dilatancy as a likely explanation for the high-frequency pulses recorded at Onahama port. The simulations also suggest that the occurrence of high-frequency spikes coincided with a rapid increase in pore water pressure in the upper part of the sand deposit between 145 and 170 s. This sudden increase is possibly linked to a burst of high-frequency energy from a large slip patch below the Iwaki region