Search

This paper explored the effects of ammonium bicarbonate and different ratios of epoxy to polyamide on the formation of porous epoxy micro-beads through a single epoxy droplet. A single drop of a mixture, consisting of epoxy, polyamide, and ammonium bicarbonate, was dropped into heated corn oil at a temperature of 100 °C. An epoxy droplet was formed due to the immiscibility of the epoxy mixture and corn oil. The ammonium bicarbonate within this droplet underwent a decomposition reaction, while the epoxy and polyamide underwent a curing reaction, to form porous epoxy micro-beads. The result showed that the higher ammonium bicarbonate content in the porous, epoxy micro-beads increased the decomposition rate up to 11.52 × 10 -3 cm 3 /s. In addition, a higher total volume of gas was generated when a higher ammonium bicarbonate content was decomposed. This led to the formation of porous epoxy micro-beads with a smaller particle size, lower specific gravity, and better thermal stability. At an epoxy to polyamide ratio of 10:6, many smaller micro-beads, with particle sizes ranging from 201 to 400 μm, were obtained at an ammonium bicarbonate content of 10 phr. Moreover, the porous epoxy micro-beads with open pores were shown to have a low specific gravity of about 0.93 and high thermal stability at a high ammonium bicarbonate content. Based on the findings, it was concluded that porous epoxy micro-beads were successfully produced using a single epoxy droplet in heated corn oil, where their shape and particle size depended on the content of ammonium bicarbonate and the ratio of epoxy to polyamide used.

Bones are nanocomposites consisting of a collagenous fibre network, embedded with calcium phosphates mainly hydroxyapatite (HA) nanocrystallites. As bones are subjected to continuous loading and unloading process every day, they often tend to become prone to fatigue and breakdown. Therefore, this review addresses the use of nanocomposites particularly polymers reinforced with nanoceramics that can be used as load bearing bone implants. Further, nanocomposite preparation and dispersion modification techniques have been highlighted along with thorough discussion on the influence that various nanofillers have on the physico-mechanical properties of nanocomposites in relation to that of natural bone properties. This review updates the nanocomposites that meet the physico-mechanical properties (strength and elasticity) as well as biocompatibility requirement of a load bearing bone implant and also attempts to highlight the gaps in the reported studies to address the fatigue and creep properties of the nanocomposites., (Copyright © 2016 Elsevier B.V. All rights reserved.)

Background: Protein microarrays have enormous potential as in vitro diagnostic tools stemming from the ability to miniaturize whilst generating maximum evaluation of diagnostically relevant information from minute amounts of sample. In this report, we present a method known as repeatable arrays of proteins using immobilized DNA microplates (RAPID-M) for high-throughput in situ protein microarray fabrication. The RAPID-M technology comprises of cell-free expression using immobilized DNA templates and in situ protein purification onto standard microarray slides., Results: To demonstrate proof-of-concept, the repeatable protein arrays developed using our RAPID-M technology utilized green fluorescent protein (GFP) and a bacterial outer membrane protein (OmpA) as the proteins of interest for microarray fabrication. Cell-free expression of OmpA and GFP proteins using beads-immobilized DNA yielded protein bands with the expected molecular sizes of 27 and 30 kDa, respectively. We demonstrate that the beads-immobilized DNA remained stable for at least four cycles of cell-free expression. The OmpA and GFP proteins were still functional after in situ purification on the Ni-NTA microarray slide., Conclusion: The RAPID-M platform for protein microarray fabrication of two different representative proteins was successfully developed.