Search

A major, unprecedented improvement in the durability of polymer electrolyte membrane fuel cells is obtained by tuning the properties of the interface between the catalyst and the ionomer by choosing the appropriate dispersing medium. While a fuel cell cathode prepared from aqueous dispersion showed 90 mV loss at 0.8 A cm(-2) after 30,000 potential cycles (0.6-1.0 V), a fuel cell cathode prepared from glycerol dispersion exhibited only 20 mV loss after 70,000 cycles. This minimum performance loss occurs even though there was an over 80% reduction of electrochemical surface area of the Pt catalyst. These findings indicate that a proper understanding and control of the catalyst-water-ionomer (three-phase) interfaces is even more important for maintaining fuel cell durability in typical electrodes than catalyst agglomeration, and this opens up a novel path for tailoring the functional properties of electrified interfaces.

Adhesion between binders and explosive crystals is of critical importance for the mechanical performance of plastic-bonded explosives (PBXs). The surface properties of several prospective binders have been determined from static advancing contact angle measurements. The surface energies have been used to calculate theoretical work of adhesion to 1,3,5-triamino-2,4,6-trinitrobenzene (TATB), a common insensitive high explosive. The fluorinated terpolymer Oxy-461™, and Kel-F™ chlorotrifluoroethylene-vinylidene fluoride copolymers show the greatest potential for wetting TATB surfaces, and should promote the best adhesion to TATB in PBX formulations. In general, none of the fluoropolymer binders investigated here exhibit markedly superior adhesion to TATB. Thus, bulk physical properties are likely to be more important when choosing a binder., (Copyright © 2010 Elsevier Inc. All rights reserved.)