Search

Laminated glass interlayer materials polyvinyl butyral (PVB) and SentryGlas ® (SG, kuraray, Houstan, TX, USA) exhibit thermal viscoelastic behavior under dynamic tensile loading. Significant temperature and strain rate effects on the behavior of these interlayer materials pose a challenge for accurately modeling the dynamic response of laminated glass. Many researchers have simplified their approaches by modeling the response of the interlayer material using a bilinear approximation or established hyperelastic models. However, temperature and strain rate effects can be captured using the three-network viscoplastic (TNV) model. Therefore, the objective of this study is to calibrate material models for the thermal viscoelastic dynamic responses of PVB and SG interlayer materials. Uniaxial tensile tests were performed at strain rates of 2, 20, and 45 s -1 and temperatures of 0, 23, and 60 °C, and material models were calibrated using the experimental data. Finite element analysis using the calibrated material models successfully predicted the dynamic responses of PVB and SG under the experimental test conditions within a 10% error margin. This suggests that the calibrated models using the TNV model represent significant improvements over existing approaches to modeling the dynamic response of laminated glass. Similar procedures can be applied to other thermoplastics, laying the groundwork for establishing a standard calibration guide.

It is known that weathering action has a significant impact on polymer interlayer materials, and previous studies have evaluated certain aspects of weathering such as temperature, humidity, and UV radiation. In this paper, the environmental effect on the mechanical properties of the virgin and cured/processed polymer interlayer materials will be studied. Three polymer interlayer materials were focused, i.e., Polyvinyl butyral (PVB), Ethylene-vinyl acetate (EVA), and Ionomer (SG), due to their industrial interest. Testing setups were designed to apply the environmental effects and perform mechanical testing on the polymeric materials. Four environmental effects were studied, including water submersion (E1), constant high temperature (E2), cyclic temperature with low relative humidity (E3), cyclic temperature, and relative humidity (E4). After the exposure of these materials to these environmental effects, the samples were prepared and mechanically tested. Uniaxial tests were performed under static and high strain rates (around 45 -1 ). It was found that under dynamic load, the properties of EVA such as the strength, maximum strain, and the toughness were not significantly affected by the environmental effects. SG5000 properties were significantly affected.