Search

Organosolv pulping of bagasse was conducted following a central composite design using a two-level factorial plan involving three pulping variables (temperature: 190-210 degrees C, time: 120-180 min, organic solvent charge: 40-60% dimethyl formamide). Responses of pulp properties (yield and holocellulose, alpha-cellulose, kappa number, ash and ethanol-dichloromethane extractives contents) and the pH of the resulting wastewater to the process variables were analyzed using statistical software (MINITAB). Main factor analysis revealed that optimum pulp has the following characteristics: 82.7% (yield), 92.9 (kappa number), 95.84% (holocellulose), 83.53% (alpha-cellulose), 1.403% (ash), 2.562% (ethanol-dichloromethane extractives contents) and 6.39 (pH). These results showed that acceptable properties of pulps could be gained at 200-210 degrees C for 150 min and 40-60% DMF. Based on these results, this method could be used for pulping of bagasse equivalent NSSC concerning high yield at a fixed kappa number. In addition, bagasse could be pulped with ease to approximately 55% yield with a kappa number approximately 31. Numerical analyses showed that cooking temperature had the greatest influence on properties of obtained pulps within the DMF concentrations and cooking time as cooking variables.

Organosolv pulping of bagasse was conducted following a central composite design using a two-level factorial plan involving three pulping variables (temperature: 190-210 degrees C, time: 120-180 min, organic solvent ratio: 40-60% dimethyl formamide). Responses of pulp and handsheets properties to the process variables were analyzed using statistical software (MINITAB 14). Using values of the independent variables the variation ranges considered provided the following optimum values of the dependent variables: 82.7% (yield), 92.9 (kappa number), 1.403% (ash), 370 ml (freeness), 6290 m (breaking length), 9.4 (folding endurance), 5.955 mN m2 g(-1) (Tear index) and 2.811 kN g(-1) (Burst index) for pulps and handsheets. Results showed that acceptable physical and mechanical properties of pulps and papers similar the pulp used for bleaching could be achieved at 210 degrees C for 150 min and 50% DMF. These are the most suitable conditions for obtaining paper sheets with a high breaking length, tear and burst indices. Also bagasse could be pulped with ease to about 55.72% yield with kappa number approximately 35. The cooking temperature was a significant factor while the DMF ratio and cooking time were not as important in term of the properties of the resultant pulps and papers.