Search

This article proposes a method for identifying potential self-adequate sub-networks in the existing power distribution grid. These sub-networks can be equipped with control and protection schemes to form microgrids capable of sustaining local loads during power systems contingencies, thereby mitigating disasters. Towards identifying the best microgrid candidates, this work formulates a chance-constrained optimal distribution network partitioning (ODNP) problem addressing uncertainties in load and distributed energy resources; and presents a solution methodology using the sample average approximation (SAA) technique. Practical constraints like ensuring network radiality and availability of grid-forming generators are considered. Quality of the obtained solution is evaluated by comparison with- a) an upper bound on the probability that the identified microgrids are supply-deficient, and b) a lower bound on the objective value for the true optimization problem. Performance of the ODNP formulation is illustrated through case-studies on a modified IEEE 37-bus feeder. It is shown that the network flexibility is well utilized; the partitioning changes with risk budget; and that the SAA method is able to yield good quality solutions with modest computation cost.

Phasor Measurement Unit measurement data have been widely used in nowadays power system applications both in steady state and dynamic analysis. The performance of these applications running in utilities' energy management system depends heavily on an accurate positive sequence power system model. However, it is impractical to find this accurate model with transmission line parameters calculated directly with the PMU measurements due to ratio errors brought by instrument transformers and communication errors brought by PMUs. Therefore, a methodology is proposed in this paper to estimate the actual transmission lines parameters throughout the whole system and, at the same time, calibrate the corresponding instrument transformers. A PMU positive sequence measurement error model is proposed targeting at the aforementioned errors, which is applicable to both transposed and un-transposed transmission lines. A single line parameters estimation method is designed based on Least Squares Estimation and this error model. This method requires only one set of reference measurements and the accuracy can be propagated throughout the whole network along with the topology acquired by the introduced Edge-based Breadth-first Search algorithm. The IEEE 118-bus system and the Texas 2000-bus system are used to demonstrate the effectiveness and efficiency of the proposed method. The potential for deployment in reality is also discussed.