Search

Purifying air from dust is a very important, current topic. There are many methods to minimize the amount of dust, one of them being chamber filters. This paper presents the research results of a newly designed rectangular chamber filter. The efficiency of the dedusting process is influenced by contamination properties, but also by the construction of the apparatus, inlet, and outlet location, the ratio of certain dimensions, and the gas flow rate. The airflow containing solid particles is a multi-phase, difficult-to-describe issue, therefore an attempt to determine the trajectory of particle movement in the apparatus was carried out using the PIV method. A decrease in the dedusting efficiency was observed with the increase of the gas flow rate, as well as for smaller diameters of the solid particles. The obtained values of the efficiency of the apparatus are comparable with the values obtained for the constructions discussed in other papers.

The aim of the study was to relate the influence of the chemical composition, structure, and basic properties as hardness of the tested drill bits on resistance to their wear. The chemical composition of the drill bit was investigated using the electric excitation emission spectrometry method and EDS microanalysis. Metallographic specimens were prepared and observed to determine the structure of each tool. Hardness tests were carried out on the shank and the working part of the tools. Material wear tests were carried out on the basis of measuring the wear of the drill bit flank. It has been shown that the appropriate selection of the chemical composition and heat treatment has a significant impact on the wear resistance of cutting tools, which directly translates into their quality.

This paper summarises a series of large-scale fire suppression tests conducted to simulate a fire in the big surface and/or surface sprinkling. The subject of this paper is the research on water spraying with the use of the Turbo Jet 2011 water-foam nozzle manufactured by Supon Białystok. The results discuss the pressure losses caused by the flow through the discharge hose, spray angle, and the intensity of surface sprinkling. The greatest stream ranges and the highest maximum values of the sprinkling intensity were obtained at the capacity of 400 l/min, and a solid spray angle. The smallest values were obtained at 200 l/min, a pressure of 5 bar, and a solid spray angle. The actual pressures taking into account the losses in the hose section were calculated. As for the highest firefighting effectiveness of the stream, the authors recommended the following parameters: semi spray angle, 200 l/min, and 2.5 bar.