Search

Shot peening is currently utilized in coal-fired power plant components to mitigate scale exfoliation issues from steamside oxidation of austenitic stainless steel superheater and reheater tubing. To focus on commercially available material, this study exposed quarter-ring specimens cut from two different commercially shot peened type 304H tubes and exposed to 1 bar steam for up to 15,000 h at 550°, 600°, 625°, and 650 °C. Specimens were removed at increments to characterize the oxide thickness and microstructure. The shot peened inner surface generally retained a thin, protective Cr-rich scale with occasional Fe-rich oxide nodules at 550–625 °C. The increased oxidation resistance from shot peening began to degrade at 650 °C after as little as 5,000 h. Cut and polished faces of these specimens formed thick, Fe-rich oxides similar to polished 304H coupons. Surprisingly, the mechanically machined outer surface of the tube specimens performed similarly to the shot peened inner diameter, suggesting it had sufficient cold work to achieve a similar benefit. Electron backscatter diffraction and Vickers-hardness measurements were used to characterize post-exposure changes in underlying microstructure and mechanical properties, respectively, imparted by shot peening. [ABSTRACT FROM AUTHOR]

Chloride salts are one candidate for a >700°C concentrating solar power (CSP) cycle, however, many reports from the literature suggest very high reaction rates between chloride salts and structural alloys. Historically, a specific methodology was established for evaluating halide salt compatibility based on solution kinetics. This study returned to that paradigm where the salts are purified and evaluated in sealed capsules before moving to a flowing experiment to determine a true corrosion rate in a temperature gradient for a commercial K–Mg–Na chloride salt. Isothermal testing focused on Ni‐based alloys 230 and 600 at 600°C–800°C. The results indicated there were promising combinations of salt chemistry, temperature, and alloy composition that reduce the extent of reaction. The results of the first monometallic thermal convection loop of alloy 600 run for 1,000 hr with a peak temperature of 700°C showed low attack with rates ≤9 µm/yr. [ABSTRACT FROM AUTHOR]