Search

In this study, The ENVISAT advanced synthetic aperture radar observations from 2003 to 2010 of a descending track covering an area of 100 km × 300 km were used to map the surface velocity field in northwestern Tibet. The derived line-of-sight (LOS) velocity map revealed that interseismic deformation was mainly located on the Altyn Tagh Fault (ATF) and other four immature subsidiary faults (i.e., Tashikule Fault, Muzitage-jingyuhe Fault, Heishibeihu Fault, and Woniuhu Fault). A 2D elastic screw dislocation model was used to interpret the interferometric synthetic aperture radar (InSAR) velocity profiles, which revealed the following results. (a) The oblique movement is partitioned between left-lateral slip at a rate of 6.3 ± 1.4 mm/y on the ATF and 5.9 ± 2.8 mm/y on the subsidiary faults. The low slip rate of the ATF indicates that the ATF does not drive the northeastward extrusion of material, with most of the extrusion occurring in the eastern interior of the plateau and the four subsidiary faults localizing the oblique convergence partitioned in the west. This can reasonably explain why catastrophic earthquakes and rapid slip do not occur all over along the ATF. (b) Based on the four subsidiary faults accommodating the oblique movement and the traces amalgamation with the EKLF (delineated Bayan Har plate boundary to the northeast), we concluded guardedly that the four subsidiary faults are the evoluting plate boundary of the Bayan Har block to the northwest. (c) The Tanan top-up structure had an uplift rate of ~0.6 mm/y at the south of the Tarim Basin. [ABSTRACT FROM AUTHOR]

Based on the working principle of satellite radars, the earthquake deformation field measured by interferometric synthetic aperture (InSAR) is the projection of ground displacement associated with the seismogenic fault in the line of sight (LOS) of the satellite. However, LOS projections are complex, and are not only related to the ascending/descending modes and incidence angles of SAR data, but also related to the strike and motion senses of the fault. Even for the same earthquake, the LOS deformation derived from different ascending/descending data can be almost identical in one case, but quite different in another case, which makes the interpretation of InSAR seismic deformation and its comparison with field observations difficult. In this study, we undertook a quantitative analysis of the relationships between LOS observation sensitivity of InSAR and fault strike, fault motion sense, and ascending/descending modes, as well as 3D deformation fields. We studied the features and differences of the LOS deformation fields in different types of earthquakes using ascending/descending modes, with a particularly detailed analysis of the relations for a strike-slip type of earthquake. We also summarized the characteristics of LOS deformation fields of faults with different strikes and optimal observational data modes. Taking the strike-slip Yushu earthquake and the normal Gaize event as examples, we used SAR data of the ascending/descending modes to verify the results of quantitative calculations. These analyses will not only provide a more reasonable interpretation of InSAR seismic deformation fields and but also help understand the differences of seismic deformation fields revealed by data with different observational modes, therefore promoting the application of InSAR technology in seismology. [ABSTRACT FROM AUTHOR]

On September 16, 2015, a magnitude 8.3 earthquake struck west of Illapel, Chile. We analyzed Sentinel-1A/IW InSAR data on the descending track acquired before and after the Chile Mw8.3 earthquake of 16 September 2015. We found that the coseismic deformation field of this event consists of many semi circular fringes protruding to east in an approximately 300km long and 190km wide region. The maximum coseismic displacement is about 1.33m in LOS direction corresponding to subsidence or westward shift of the ground. We inverted the coseismic fault slip based on a small-dip single plane fault model in a homogeneous elastic half space. The inverted coseismic slip mainly concentrates at shallow depth above the hypocenter with a symmetry shape. The rupture length along strike is about 340 km with maximum slip of about 8.16m near the trench. The estimated moment is 3.126×1021 N.m(Mw8.27), the maximum depth of coseismic slip near zero appears to 50km. We also analyzed the postseismic deformation fields using four interferograms with different time intervals. The results show that postseismic deformation occurred in a narrow area of approximately 65km wide with maximum slip 11cm, and its predominant motion changes from uplift to subsidence with time. that is to say, at first, the postseismic deformation direction is opposite to that of coseismic deformation, then it tends to be consistent with coseismic deformation. It maybe indicates the differences and changes in the velocity between the Nazca oceanic plate and the South American continental plate. [ABSTRACT FROM AUTHOR]

Interferometric synthetic aperture radar (InSAR) data from 6 Envisat ASAR descending tracks; spanning the 2003–2010 period; was used to measure interseismic strain accumulation across the Northeastern Tibetan Plateau. Mean line-of-sight (LOS) ratemaps are computed by stacking atmospheric-corrected and orbital-corrected interferograms. The ratemaps from one track with different atmospheric-corrected results or two parallel; partially overlapping tracks; show a consistent pattern of left-lateral motion across the fault; which demonstrates the MERIS and ECMWF atmospheric correction works satisfactorily for small stain measurement of this region; even with a limited number of interferograms. By combining the measurements of InSAR and GPS; a fine crustal deformation velocity and strain rate field was estimated on discrete points with irregular density depending on the fault location; which revealed that the present-day slip rate on the Haiyuan fault system varies little from west to east. A change (2–3 mm/year) in line-of-sight (LOS) deformation rate across the fault is observed from the Jinqianghe segment to its eastern end. Inversion from the cross-fault InSAR profiles gave a shallow locking depth of 3–6 km on the main rupture of the 1920 earthquake. We therefore infer that the middle-lower part of the seismogenic layer on the 1920 rupture is not yet fully locked since the 1920 large earthquake. Benefit from high spatial resolution InSAR data; a low strain accumulation zone with high strain rates on its two ends was detected; which corresponds to the creeping segment; i.e., the Laohushan fault segment. Contrary to the previous knowledge of squeezing structure; an abnormal tension zone is disclosed from the direction map of principal stress; which is consistent with the recent geological study. The distribution of principal stress also showed that the expanding frontier of the northeastern plateau has crossed the Liupan Shan fault zone; even arrived at the northeast area of the Xiaoguan Shan. This result agrees with the deep seismic reflection profile. [ABSTRACT FROM AUTHOR]