Search

Wind sensors have always played an irreplaceable role in environmental information monitoring and are expected to operate with lower power consumption to extend service lifetime. Here, we propose a breeze wake-up anemometer (B-WA) based on a rolling-bearing triboelectric nanogenerator (RB-TENG) with extremely low static power. The B-WA consists of two RB-TENGs, a self-waking-up module (SWM), a signal processing module (SPM), and a wireless transmission unit. The two RB-TENGs are employed for system activation and wind-speed sensing. Once the ambient wind-speed exceeds 2 m/s, the wake TENG (W-TENG) and the SWM can wake up the system within 0.96 s. At the same time, the SPM starts to calculate the signal frequency from the measured TENG (M-TENG) to monitor the wind speed with a sensitivity of 9.45 Hz/(m/s). After the wind stops, the SWM can switch off the B-WA within 0.52 s to decrease the system energy loss. In quiescent on-duty mode, the operating power of the B-WA is less than 30 nW, which can greatly extend the service lifetime of the B-WA. By integrating triboelectric devices and rolling bearings, this work has realized an ultralow quiescent power and self-waked-up wireless wind-speed monitoring system, which has foreseeable applications in remote weather monitoring, IoT nodes, and so on. [ABSTRACT FROM AUTHOR]

Triboelectric nanogenerators (TENGs) can directly harvest energy via solid–liquid interface contact electrification, making them very suitable for harvesting raindrop energy and as active rainfall sensors. This technology is promising for realizing a fully self-powered system for autonomous rainfall monitoring combined with energy harvesting/sensing. Here, we report a raindrop energy-powered autonomous rainfall monitoring and wireless transmission system (R-RMS), in which a raindrop-TENG (R-TENG) array simultaneously serves as a raindrop energy harvester and rainfall sensor. At a rainfall intensity of 71 mm/min, the R-TENG array can generate an average short-circuit current, open-circuit voltage, and maximum output power of 15 μA, 1800 V, and 325 μW, respectively. The collected energy can be adjusted to act as a stable 2.5 V direct-current source for the whole system by a power management circuit. Meanwhile, the R-TENG array acts as a rainfall sensor, in which the output signal can be monitored and the measured data are wirelessly transmitted. Under a rainfall intensity of 71 mm/min, the R-RMS can be continuously powered and autonomously transmit rainfall data once every 4 min. This work has paved the way for raindrop energy-powered wireless hyetometers, which have exhibited broad prospects in unattended weather monitoring, field surveys, and the Internet of Things. [ABSTRACT FROM AUTHOR]