Search

Facial reconstructive surgery has already implemented the use of 3D printed Patient Specific Implants derived from CAD/CAM-based technologies as an alternative to preformed bone graft substitutes. 3D-printed patient-specific implants derived from CAD/CAM-based technologies are used in facial reconstructive surgery as an alternative to preformed bone graft substitutes. However, to minimize the invasiveness and long-term adverse effects of surgical interventions, the implant needs to exhibit exact fitting, porosity, density, and volume and be made from resorbable materials that allow ingrowth and formation of new bone tissue. Therefore, we present this pilot study using 3D-printed implants consisting of pure β-TCP, produced using a novel technique that assures these properties. Eight pigs received 3D-printed truncated porous cone bone implants paired with either an off-the-shelve a chronOS (DePuy Synthes chronOS Vivify Preforms) preformed block (n = 4) or a no-implant void (n = 4) in a surgically created defect on each side of the angle of the mandible. After 6 months, CT data showed that all 3D-printed implants performed as well as did the off-the-shelve implants, with predicted osteointegration medially and laterally and with minimal gapping between the implants and native bone. The CT findings were confirmed by histological analysis that revealed that the 3D-printed implants together with the off-the-shelve implants were almost complete resorbed. Much of the resorbed volume had been replaced by vascularized compact bone, and fusion between newly formed bone and native bone was observed in all implants, further indicating that the 3D-printed implants and off-the-shelve implants performed equally well. Only soft tissue developed in the void control sites. Further studies are needed to confirm these initial findings. [Display omitted] • The P3D implants have almost been resorbed indicating biodegradability properties of β-TCP in mini pigs • The resorbed P3D implants have been replaced by vascularized compact bone after 6 months allowing osteointegration to occur • The bone replacement observed in ChronOS and P3D implants was almost similar suggesting a resemble in bone healing properties • No immune reaction and exudation occurred in the pigs with either ChronOS or P3D implants. [ABSTRACT FROM AUTHOR]

This study evaluated clinical outcomes following intraoperative use of adult mesenchymal stem cells ( MSCs) in various oral reconstructive procedures. PubMed was searched without language restrictions from 2000 to 2011 using the search words stem cell, oral surgery, tissue engineering, sinus lift, bone regeneration and combinations of these. Inclusion criteria were intraoperative use of MSCs in the study design. Reference lists of the articles found were searched for other related studies. Eighteen clinical trials using MSCs for sinus augmentation were found: five case reports on the repair of large bony defects and six studies on ridge augmentation and healing of alveolar sockets after third molar extraction. The findings suggest that MSCs are capable of producing in vivo bone, re-establishing lost tissue and facilitating placement of dental implants. Use of MSCs would reduce patient morbidity because of a less stressful harvesting technique than that of autogenous bone. The majority of clinical trials indicate that MSCs can produce bone in vivo. However, a satisfactory outcome was not seen in all studies, and due to the diversity of study designs, a 'golden approach' cannot be determined. Before use of MSCs can be considered as a first-choice treatment, more predictable outcomes and better long-term prognoses need to be established. Conventional bone grafting remains the gold standard. [ABSTRACT FROM AUTHOR]