Search

This paper presents an extension of previous methods in order to find electrical series connections between multiphase machines, allowing the independent control of each one of them. These new electrical series connections explore the symmetrical disposition of the phases of even-multiphase machines, allowing the inversed connection of some of the phases, different from the direct connections as it was previously done. Therefore, electrical series connections of two symmetrical six-phase or of four symmetrical ten-phase machines are now possible. Besides that, this new solution ensures a natural independent control of permanent-magnet synchronous machines even if the back electromotive forces (back EMFs) generated by the rotor are not sinusoidal, without need of special machine conception or supplementary control strategy. This control independency is mathematically proved using the decomposition of multiphase machines in fictitious diphase and homopolar machines. Experimental results are presented to show the functioning and the advantages of this new coupling for two symmetrical six-phase permanent-magnet synchronous machines (PMSMs). [ABSTRACT FROM AUTHOR]

This paper analyzes two fault-tolerant dual-multiphase motor drives, a series-connected topology, and a standard H-bridge topology. Previous studies have shown that the series connected topology is appropriate to an aerospace application and has lower peak current in degraded mode in comparison with the H-bridge topology, which may consequently diminish the system's weight and cost. This paper extends the study to compare different control strategies of these structures under two fault conditions: short-circuit of an inverter's switch and an open-phase of the machine. The control strategies analyzed in this paper do not impact the fundamental current or the torque generation, but the amplitudes of some harmonics in degraded mode are expected to be narrowed down in order to reduce the inverter's size. Some analyses of maximum voltage and peak current in degraded mode have been used for inverter dimensioning. Experimental results are shown and compared to the simulated ones to confirm the validity of this study. [ABSTRACT FROM PUBLISHER]