Search

Differences between breaker bar evolution under high energy (erosive) and subsequent mild energy (accretive) wave conditions are studied based on three data sets from large-scale morphodynamic experiments. Under erosive wave conditions, a clear linear relationship between the height and the cross-shore location of the breaker bar is observed. The similar cross-shore shape of the sediment transport magnitudes underlines the similarity of the bar evolution under erosive wave conditions. Under the subsequent accretive wave conditions, two major evolution patterns are observed during onshore migration (decaying or non-decaying breaker bar). In the presented data, the feedback between the wave conditions and the beach morphology determines if a bar decays during onshore migration. This feedback involves that the wave breaking location depends on the morphology and on the wave conditions resulting in differences in sediment transport patterns between the two types of onshore bar migration. A comparison against numerous other experimental beach profile data sets strongly supports the linear relationship between bar height and bar location under erosive wave conditions. For accretive wave conditions, the number of comparable data sets is very limited. The comparison underlines that breaker bar evolution under accretive wave conditions cannot be condensed to a single pattern as under erosive wave conditions. [ABSTRACT FROM AUTHOR]

Beach profile evolution under storm sequence forcing presents an emerging research topic that has only been investigated at a limited number of sites. The occurrence and effects of storm sequencing on beach profile evolution are studied at Hasaki Beach, Japan, using weekly beach profile and two-hourly offshore wave measurements. During the 25-year study period, the supratidal beach at Hasaki is subjected to long-term accretion and steepening while the shoreline shows a long-term oscillation. In addition, oscillations of the supratidal beach volume and the shoreline at semi-annual and annual intervals are identified, which are largely controlled by the variability of the wave height. Hasaki Beach is subjected to frequent storms that often cluster in sequences, especially during the extra-tropical cyclone season (January to March). The majority of storms and sequences generate erosion of the beach above the low water level but some also lead to recovery. Despite a tendency for storms and storm sequences with larger power to cause more erosion, the present data does not demonstrate increased beach erosion by storm sequences. Following these findings, the tendency of the beach to evolve towards equilibrium and the importance of the antecedent beach morphology are demonstrated. • Accretion and steepening of the supratidal beach at Hasaki during the 25-year study period. • Annual and semi-annual oscillations of the shoreline, supratidal and intertidal beach volume are controlled by the wave energy. • Storms and storm sequences are quantitatively defined for Hasaki Beach and the definitions are discussed. • No indication for increased erosive effect due to storm sequences compared to individual storms of equivalent power • The antecedent beach morphology and the evolution of the beach towards equilibrium are found to be important. [ABSTRACT FROM AUTHOR]

New large-scale experiments on the influence of storm sequencing on beach profile evolution are presented. The experiments comprised three sequences that commenced from the same initial beach profile. Each sequence consisted of two storms of different energy, with each storm followed by a recovery phase. A specific focus of the experiments was the influence of storm chronology as well as the influence of the recovery wave energy and duration on beach evolution. The breaker bar and the shoreline are studied as indicators for the beach response. Both evolve towards an equilibrium location for each wave condition where the breaker bar reaches its equilibrium much faster than the shoreline. Overall, no enhanced beach erosion due to storm sequencing is observed. Despite a similar cumulative wave power of the three sequences, the final beach configuration of each sequence seems to be determined by the last wave condition instead of previous storms. However, storm sequencing is important when the beach profile has not yet fully recovered before being disrupted by the subsequent storm. In this case, the second storm does not necessarily cause further erosion but can result in onshore sediment transport and hence, form part of the recovery. The bulk onshore sediment transport as well as the shoreline recovery rate vary depending on the wave condition and the profile disequilibrium and show a maximum value for a recovery condition with an intermediate wave energy. The very low energy condition that was performed for a long duration (24 hours) generated a near-stationary beach profile with typical features of a reflective beach. • New large-scale experiments on storm sequencing and beach response. • The beach evolves towards an equilibrium state under the performed storm sequences. • The rate of beach change varies depending on the antecedent beach morphology. • Largest bulk onshore sediment transport occurs for intermediate low energy conditions. • A very low energy condition of long duration (24 h) results in a reflective beach profile. [ABSTRACT FROM AUTHOR]

Large-scale experiments on beach profile evolution, performed within the HYDRALAB+ experiments 'RESIST', will be presented providing new insights into the influence of storm sequencing on beach response. Three storm sequences with the same cumulative wave power were generated; each sequence consisted of two high energy (storm) wave conditions each of which was followed by a recovery stage. Beach profile measurements, observations of the wave breaking location and sediment bed samples are used to study the influence of storm sequences on beach profile evolution, including the effect of storm chronology and beach recovery of different energy and duration.The beach profile is found to evolve towards an equilibrium state that is specific for each wave condition indicating no cumulative effect of storm sequencing on beach erosion in the present experiments. This means that, despite the same cumulative power of each sequence, the final beach configuration of each sequence is different and it depends on the wave condition that was performed at the end of the sequence. Storm sequencing is, however, important for the rate of beach change: As the beach evolves towards equilibrium for each wave condition, the rate of beach change varies for the same wave conditions but different initial beach profiles (different sequencing). This means that the same wave condition can result in either beach erosion or recovery depending on if the beach is in recovered or eroded condition compared to the equilibrium beach configuration for these wave conditions.This contribution will present one of the first large-scale data sets comprising more than one high energy and subsequent recovery stage in one sequence. We will discuss the influence of the storm chronology, beach equilibrium configuration and recovery conditions on the beach profile evolution. [ABSTRACT FROM AUTHOR]

Sand transport processes and net transport rates are studied in a large-scale laboratory swash zone. Bichromatic waves with a phase modulation were generated, producing two continuously alternating swash events that have similar offshore wave statistics but which differ in terms of wave-swash interactions. Measured sand suspension and sheet flow dynamics show strong temporal and spatial variability, related to variations in flow velocity and locations of wave capture and wave-backwash interactions. Suspended and sheet flow layer transport rates in the lower swash zone are generally of same magnitude, but sheet flow exceeds the suspended load transport by up to a factor four during the early uprush. The bed level near the inner surf zone is relatively steady during a swash cycle, but changes of O (cm/s) are measured near the mid swash zone where wave-swash interactions lead to strongly non-uniform flows. The two alternating swash events produce a dynamic equilibrium, with bed level changes up to a few mm induced by single swash events, but with net morphodynamic change over multiple events that is two orders of magnitude lower. Most of the intra-swash and the single-event-averaged bed level changes in the swash zone are caused by a redistribution of sediment within the swash. The transport of sediment across the surf-swash boundary is minor at intra-swash time scale, but becomes increasingly significant at swash-averaged time scales or longer (i.e., averaged over multiple swash events). •Large-scale wave flume experiments involving two alternating bichromatic wave induced swash events. •Sediment mobilization as sheet load and suspended load increases substantially from inner surf to lower swash zone. •Sheet flow transport dominates the total transport during the early uprush and during instants of strong wave-backwash interactions. •Single swash events can produce much greater net transport rates and bed level changes than the overall trend over multiple events. •The sediment exchange across the surf-swash boundary becomes increasingly significant when integrated over larger time scales. [ABSTRACT FROM AUTHOR]