Search

The modelling of a three‐phase four‐leg four‐wire grid‐forming inverter in a low voltage distribution system 18‐bus European Cigré under unbalanced conditions in an autonomous distribution network is presented. The case study has two types of inverters control strategy: (i) grid‐forming to supply all the system demand in the interval of the intentional supply interruption and (ii) grid‐following to integrate photovoltaic renewable energy resources into power systems. The model suggests a control scheme with two loops: An inner current loop with a proportional‐integral controller and an outer voltage loop with a proportional controller, both in the synchronous reference frame (dq0), in which dq‐axis are decomposed in positive and negative sequences. Simulation results, carried out using the PSCAD software, showed the effectiveness of the suggested control strategy with smooth synchronization where the grid‐forming inverter was able to form a network with an unbalanced degree lower than 2%, sinusoidal voltage and frequency within standard limits 49.5–50.5 Hz. [ABSTRACT FROM AUTHOR]

As the penetration of inverter-based distributed generations into microgrids continues to rise, the significance of power electronic inverters in modern power systems becomes increasingly pronounced. They are designed to have fault ride-through capabilities, enabling them to sustain operation even during and after fault conditions. This paper presents a novel voltage compensation strategy based on the line impedances addressing both positive and negative-sequence aspects, for a three-phase three-wire inverter deployed to regulate the low-voltage network during unsymmetrical faults, thereby preserving voltage stability. The control strategy is carried out in a synchronous reference frame (dq) to govern the positive and negative-sequence voltages and currents of the inverter. By synthesizing AC currents, the inverter restores the positive-sequence voltage to its rated value while mitigating negative-sequence voltage at the point of common coupling arising from unsymmetrical faults. Through MATLAB/Simulink, are investigated three unsymmetrical fault scenarios (single line-to-ground, line-to-line, and double line-to-ground faults) within the low-voltage distribution network of the 18-bus European Cigré, incorporating three inverters equipped with the proposed voltage support capability. The results confirm that inverter-interfaced distributed generators with local voltage support can improve the system's fault ride-through capability by reducing voltage drops and unbalances. • Voltage resilience in the face of short-circuit challenges. • Balancing voltage fluctuations during grid faults. • Grid-supporting inverters optimize fault response. [ABSTRACT FROM AUTHOR]

In the past decade, inverter-integrated energy sources have experienced rapid growth, which leads to operating challenges associated with reduced system inertia and intermittent power generation, which can cause instability and performance issues of the power system. Improved control schemes for inverters are necessary to ensure the stability and resilience of the power system. Grid-forming inverters dampen frequency fluctuations in the power system, while grid-following inverters can aggravate frequency problems with increased penetration. This paper aims at reviewing the role of grid-forming inverters in the power system, including their topology, control strategies, challenges, sizing, and location. In order to facilitate continued research in this field, a comprehensive literature review and classification of the studies are conducted, followed by research gaps and suggestions for future studies. [ABSTRACT FROM AUTHOR]