Search

This paper presents a new permanent-magnet gear based on the cycloid gearing principle, which normally is characterized by an extreme torque density and a very high gearing ratio. An initial design of the proposed magnetic gear was designed, analyzed, and optimized with an analytical model regarding torque density. The results were promising as compared to other high-performance magnetic-gear designs. A test model was constructed to verify the analytical model. [ABSTRACT FROM AUTHOR]

This paper presents calculation and measurement it- suits of a high-performance permanent-magnetic gear. The analyzed permanent-magnetic gear has a gear ratio of 5.5 and is able to deliver 27 N-m. The analysis has shown that special attention needs to be paid to the system where the gear is to be installed because of a low natural torsion spring constant. The analyzed gear was also constructed in practice in order to validate the analysis and predict the efficiency. The measured torque from the magnetic gear was only 16 N-m reduced by the large end-effects. A systematic analysis of the loss components in the magnetic gear is also performed in order to figure out why the efficiency for the actual construction was only 81 %. A large magnetic loss component originated in the bearings, where an unplanned extra bearing was necessary due to mechanical problems. Without the losses of magnetic origin in the bearings and less end-effects caused by relatively short stack, an impressive efficiency estimated at 96% can be obtained. Comparison with classical mechanical gears has shown that the magnetic gear has a better efficiency and a comparable torque per volume density. Finally, it is concluded that the results in this paper may help to initiate a shift from mechanical gears to magnetic gears. [ABSTRACT FROM AUTHOR]

This study focuses on a hydraulic cylinder that is directly connected to a fixed-displacement hydraulic pump driven by an electric servo motor. This particular setup is referred to as a one-motor-one-pump motor-controlled hydraulic cylinder (MCC). This paper presents a new approach to address mode switching oscillation (MSO) in MCCs by incorporating system pressure control capabilities. It conducts a detailed investigation into the factors that contribute to MSO in standard MCCs and thoroughly evaluates the effectiveness of the proposed system in mitigating MSO. The simulation results demonstrate the successful suppression of MSO. In conclusion, the proposed MCC with system pressure control capabilities is validated and, furthermore, it shows great potential for practical applications involving small loads and rapid retraction. [ABSTRACT FROM AUTHOR]

This paper is concerned with a hydraulic cylinder directly controlled by a variable speed motor-driven fixed-displacement pump. The considered configuration is referred to as a one-motor-one-pump (1M1P) motor-controlled hydraulic cylinder (MCC). A 1M1P MCC with a hydraulically driven passive load-holding function enabled by controlled system pressures is proposed. The proposed load-holding functionality works if there is a standstill command, a loss of power supply, or a hose rupture. Additionally, this paper conducts a comprehensive analysis of the proposed system's operation and load-holding function across four quadrants. The simulation results demonstrate four-quadrant operation and good load-holding performance under the aforementioned scenarios. In conclusion, the proposed 1M1P MCC can be successfully used on practical applications characterized by overrunning loads and four quadrant operation. [ABSTRACT FROM AUTHOR]