Search

In order to reduce the energy consumption of HVAC systems in buildings, the use of energy-saving solutions is necessary. One of these solutions is ventilation, which is usually used for maintaining acceptable indoor air quality and thermal comfort. As the change in outdoor environment is unpredictable and the occupant control is spontaneous, it is critical to control the windows and HVAC systems to achieve a maximum use of outdoor air for indoor ventilation. A new rule-based control strategy that could change the opening factor of windows is proposed in this study and its effectiveness was tested in five representative climates, ranging from a subtropical region to a severely cold region. A building model was set up and the indoor air temperature and energy consumption were predicted using EnergyPlus. The results show that the proposed control strategy can utilize ventilation to maintain a comfortable indoor environment with an annual uncomfortable percentage in an occupied period lower than 5%, thus leading to an energy-saving rate of 13.5–55.6%. The simulation results indicate that there are periods of ventilation available during the summer in climate zones with hot summers and warm winters, whereas the control strategy has a better energy-saving performance in temperate areas. This study conducted a preliminary exploration for practical applications of the combined operation of controllable natural ventilation and HVAC systems in buildings. [ABSTRACT FROM AUTHOR]

As most residents spend more than 90% of their time in buildings, acceptable and reasonable control of both indoor thermal comfort and air quality is imperative to ensure occupants' health status and work productivity. However, current control strategies generally take either thermal comfort or indoor air quality as a single loop, rather than the concurrent control of two. To analyze their mutual influence, this study investigated the performance of three multi-control approaches, i.e., proportional integral derivative (PID) control of thermal comfort and a fixed outdoor air ratio, PID control of thermal comfort and design outdoor air rate, and PID control of thermal comfort and occupancy-based demand-controlled ventilation. As a pilot study, three typical control methods were implemented to a multi-zone building via OpenModelica modeling. The results indicate that indoor air temperature can be well-maintained under three control methods, however, the CO2 concentration under the fixed outdoor air ratio was over 1000 ppm, leading to poor indoor air quality. The control strategy with the design outdoor air rate could not properly ensure the CO2 concentration, due to the over-ventilated or under-ventilated phenomena, subsequently resulting in unnecessary energy waste. The occupancy-based demand controlled ventilation could maintain the CO2 concentration under the set-point with an intermediate power energy utilization. [ABSTRACT FROM AUTHOR]