Search

One of the key technologies of stacked projectile weapons is projectile positioning. However, the present projectile positioning structures have their respective advantages and shortcomings. A new structure based on the self-locking principle is put forward in this paper and verified as feasible by static analysis if the proper material and structural parameters are chosen. In order to check the strength and verify the feasibility of the structure under launch conditions, the multibody contact finite element model of the structure is established, coupled with dynamic load in the interior ballistic cycle. According to simulations and analysis, the projectile positioning structure is feasible and the strength of the projectile can meet the strength requirement for launch conditions. For different maximum static friction coefficients, simulations show that an increase in the maximum static friction coefficient between the contact surfaces of the positioning ring and barrel improves the positioning performance, but an increase in the maximum static friction coefficient between the contact surfaces of the positioning ring and projectile worsens. On the basis of great computation, it is found that an increase in the upper thickness and height of the positioning ring improves the positioning performance, but an increase in the lower thickness worsens the positioning performance. Further, a lower thickness affects the positioning performance more greatly. As a result, the positioning ring will be thin and light to improve the positioning performance. Compared with other positioning structures, the new structure has little influence on the ballistic performance and is a good application prospect. [ABSTRACT FROM AUTHOR]

Guided projectile terminal phase against target at ground level is investigated using an adjoint simulation. A pseudo-optimal projectile navigation gain is looked for against a target disturbing the projectile guidance. The use of counter-measures is "modeled" as a suddenly detected target abrupt motion during the guidance terminal phase. The miss distances obtained are studied and the projectile optimal navigation gain is chosen based on the maximum tolerated miss distance. [ABSTRACT FROM AUTHOR]

In this paper, the influence of mesh sensitivity on the fracture predictions during penetration and perforation of hardened blunt-nose cylindrical steel projectiles in plates of Weldox 460E, Weldox 700E, and Weldox 900E steel has been studied. The main objective is to try to describe the experimentally obtained trend of a decrease in ballistic limit velocity with increased target strength when the plates are impacted by blunt projectiles. This behavior is due to the occurrence of highly localized shear bands as the target strength increases. The impact tests are analyzed using the explicit solver of a nonlinear finite element code. A thermoelastic-thermoviscoplastic constitutive model with coupled or uncoupled ductile damage was used in the simulations. It was found that the residual velocity continuously increases when the element size is decreased from 125 μm to 15μm in the shear zone, and that this increase is significantly stronger for impact velocities close to the ballistic limit. The ballistic limit decreases by up to 25% when the size of the element is decreased from 125 μm to 30 μm; the decrease being somewhat greater for the two steels with the highest strength. Even with the finest mesh, the experimental trend of a decreasing ballistic limit with increasing target strength was not predicted in the simulations, neither with coupled nor uncoupled damage. Nonlocal simulations based on smoothing of the damage and temperature fields, which are the two variables causing the softening, were carried out for the Weldox steels and a mesh size of 30 μm. These simulations indicate a reduction in the mesh sensitivity for both the coupled and uncoupled damage approaches when nonlocal averaging is employed. [ABSTRACT FROM AUTHOR]