Search

Eucalyptus (Eucalyptus spp.) leads to depletion of nutrients from the soil due to its fast growing nature. Therefore, a pot experiment was conducted to study the effect of zinc (Zn) application on clonal eucalyptus growth, biomass output and its uptake, as well as response of eucalyptus to Zn in soils of three textures. The treatments consisted of eight levels of Zn (0, 5, 10, 15, 20, 25, 30, and 35 mg kg−1 applied through ZnSO4.H2O) in a completely randomized design triplicated in soils of three distinct textures (loamy sand, sandy loam and sandy clay). The plant height, collar diameter, dry weight of shoot and roots, soil plant analysis development (SPAD) readings, Zn concentration and uptake by leaves, stem+branches and roots increased significantly with Zn application. Average dry weight of shoot and roots (31.93 and 15.12 g plant−1, respectively) was significantly highest at 15 mg Zn kg−1 whereas Zn concentration and uptake (18.35 mg kg−1 and 286.2 µg plant−1, respectively) by roots were highest at 20 mg Zn kg−1. The above parameters differed significantly among soils as sandy clay>sandy loam>loamy sand except Zn content and uptake by roots and SPAD values which were highest in sandy loam soil. Loamy sand and sandy loam soil exhibited higher Zn use efficiency, shoot biomass response and uptake response to applied Zn than sandy clay soil. It is concluded to apply 20 mg Zn kg−1 in light soil and 15 mg Zn kg−1 in heavy textured soil for better growth and productivity of eucalyptus. [ABSTRACT FROM AUTHOR]

The agricultural frontier in Brazil advances mainly in areas of sandy soils, where the management of soil fertility is still a challenge, including the practice of liming. Limestone dissolution was investigated under varying doses (0–40 t ha−1) in soil samples with a wide range of textural gradients (5%–74% clay). In view of textural variations and limestone rates, the objective was to generate information regarding pH, the residual liming effect, and exchangeable calcium (Ca) and magnesium (Mg) levels, including under overliming conditions. Throughout the textural gradient, the pH was between 4.2 and 8.5. On more sandy soils (5%–18% clay), overheating (pH > 7) was obtained with ~ 2 t ha−1 of limestone. On clayey soils (37%–74% clay), a similar effect was obtained with ~ 10 t ha−1 of limestone, indicating the marked difference in the acid buffering capacity of these soils. In addition, the equilibrium pH in the context of overliming in sandy soil was higher (8.2) compared with clayey soils (7.8). The residual liming effect was greater in sandy soils due to the lower potential acidity. Regardless of the soil texture, the Ca/Mg ratio increased in the context of overliming. Liming must be carefully applied and requires proper recommendations, especially on sandy soils, avoiding pH ≥ 6.5, a condition that is not suitable for most crops. [ABSTRACT FROM AUTHOR]