Search

The piezocone penetration test (CPTu) is a common geotechnical field test to evaluate soil properties. In interpreting the CPTu field measurements, soil drainage conditions are mostly considered completely drained or undrained; however, partial drainage conditions govern for such soils as silts or clayey sand mixtures. Previous studies show that neglecting partial drainage conditions causes incorrect estimation of soil geotechnical parameters. Most studies have been conducted using calibration chambers and centrifuge tests on clayey soils. Due to the complications in modeling the piezocone test, few numerical studies have been performed under partially drained conditions, especially on coarse-grained soils. Among the challenges of numerical modeling of CPTu, one can mention the difficulty of modeling soil structure in large strain mode and soil–water interaction behavior. In this paper, piezocone penetration tests were modeled using the advanced hypoplastic constitutive model and finite-element method. The behavior of Firoozkooh sandy soil under different drainage conditions and relative densities was analyzed. Then, the effect of cone penetration on the surrounding soils was discussed. It was shown that drainage conditions and the soil relative densities significantly affected the trend of variations in excess pore-water pressure (EPWP) generated around the piezocone. [ABSTRACT FROM AUTHOR]

Eucalyptus (Eucalyptus spp.) leads to depletion of nutrients from the soil due to its fast growing nature. Therefore, a pot experiment was conducted to study the effect of zinc (Zn) application on clonal eucalyptus growth, biomass output and its uptake, as well as response of eucalyptus to Zn in soils of three textures. The treatments consisted of eight levels of Zn (0, 5, 10, 15, 20, 25, 30, and 35 mg kg−1 applied through ZnSO4.H2O) in a completely randomized design triplicated in soils of three distinct textures (loamy sand, sandy loam and sandy clay). The plant height, collar diameter, dry weight of shoot and roots, soil plant analysis development (SPAD) readings, Zn concentration and uptake by leaves, stem+branches and roots increased significantly with Zn application. Average dry weight of shoot and roots (31.93 and 15.12 g plant−1, respectively) was significantly highest at 15 mg Zn kg−1 whereas Zn concentration and uptake (18.35 mg kg−1 and 286.2 µg plant−1, respectively) by roots were highest at 20 mg Zn kg−1. The above parameters differed significantly among soils as sandy clay>sandy loam>loamy sand except Zn content and uptake by roots and SPAD values which were highest in sandy loam soil. Loamy sand and sandy loam soil exhibited higher Zn use efficiency, shoot biomass response and uptake response to applied Zn than sandy clay soil. It is concluded to apply 20 mg Zn kg−1 in light soil and 15 mg Zn kg−1 in heavy textured soil for better growth and productivity of eucalyptus. [ABSTRACT FROM AUTHOR]