Search

Power system planning is essential for ensuring development of a safe and stable power system. Articles on power system planning have been published in recent decades. In this paper, bibliometric analysis is applied to power system planning to identify its basic characteristics, and to summarize the research hotspots and trends. A total of 4562 publications were obtained from the Web of Science during 1971–2020. The 4562 publications cover 8136 keywords, 1526 journals, 107 countries/territories, and 2519 institutions. IEEE Transactions on Power Systems is the key journal in power system planning; USA, China, and England are the countries that dominate publication production. Research hotspots and trends were analyzed using author-keyword co-occurrence analysis and keyword burst detection. Four clusters were identified and topics from Cluster I (central nodes as power system stability and transient stability) and Cluster IV (central nodes as power system simulation and economics) are important for power system planning research. However, their relative popularities have declined over the past two decades. This indicates that Cluster II (central nodes as renewable energy, wind power, and energy storage) and Cluster III (central nodes as distributed generation and smart grids) will be the focus of future research. [ABSTRACT FROM AUTHOR]

The high penetration of renewable energy will substantially change the power system operation. Traditionally, the annual operation of a power system can be represented by some typical operation modes and acts as the basis for the power-system-related analysis. The introduction of highly penetrated renewable energy will make the power system operation mode highly diversified and variable. These modes may not follow traditional empirical patterns. In this paper, we propose a data-driven method based on high-dimensional power system operation data (including power flow, unit generation, and load demand) to identify the pattern of the operation modes and analyze the impact of high renewable penetration. Specifically, the proposed data-driven method is composed of simulation, preprocessing, clustering, dimension reduction, and visualization with the aim to provide an intuitive understanding of the operation mode variety under high renewable penetration. In addition, several indices are introduced to quantify the space dispersion, time variation, and seasonal consistency of operation modes. A case study on actual Qinghai provincial power system in China validates the effectiveness of the proposed data-driven method and indicates that the dispersion and time variation of operation mode will significantly increase in the beginning and then saturate with the increase in renewable penetration level. The operation mode is also less correlated with seasons in renewable energy dominated power system. [ABSTRACT FROM AUTHOR]

Due to the uneven geographical distribution between load and wind power, currently it is difficult to integrate the large-scale wind power into the State Grid in China. There are significant wind curtailments for wind farms due to system restrictions. This paper proposes a new way of utilizing wind power, i.e., in-situ consumption, as an alternative to the costly development of long-distance transmission of large-scale wind power. Electrolytic aluminum load, which is one of the most typical high energy consuming loads, is employed to absorb the excess wind power in western China. An actual isolated industrial power system for aluminum production driven by wind power and coal-fired power is described. The penetration level of wind power in the isolated power system is up to 48.8%. The power imbalance between generation and load demand caused by wind power fluctuation or the tripping of coal-fired generators can dramatically impact the frequency stability of the isolated power system, which is of small inertia. An online identification method of power imbalance based on Wide Area Measurement System (WAMS) is presented. According to the characteristics of the electrolytic aluminum load, a system frequency control method by regulating the bus voltages of aluminum loads to eliminate the power imbalance is introduced. The simulation is done in Real Time Digital Simulator (RTDS) and the results verify the validity of the proposed frequency control method. [ABSTRACT FROM PUBLISHER]