Search

In this paper, a constitutive model is presented to model the behavior of various soils (sand and clay) in different loading conditions and the minimum required parameters are obtained. Although some practical features (concepts) of the bounding surface framework and modified Cam-Clay have been employed in its formulations, the model is developed mainly based on the generalized plasticity framework. Moreover, some concepts such as dilatancy relation and loading history surface are redefined. Finally, the proposed constitutive model is evaluated using the experimental data related to two different sandy soils and three different clays under different loading conditions. Finally, it is concluded that the proposed constitutive model can easily be calibrated for various clayey and sandy soils. It can depict different behavioral aspects of these soils under different monotonic and cyclic loading conditions. [ABSTRACT FROM AUTHOR]

The physical and mechanical behavior of soil polymer composites tightly depends on the properties and structures of both soil and polymer. This study aims to investigate the effect of glass transition temperature as one of the most important characteristics of adhesive resins of acrylic polymers on the geotechnical behavior of soils that have not been fully covered by previous studies. To achieve that, three similar copolymers of methyl methacrylate-co-butyl acrylate with different glass-transition temperatures of 1°C, 33°C, and 51°C were synthesized, and two representative specimens of cohesive (kaolinite clay) and noncohesive (sand) soils were chosen to perform a full investigation of the consequential changes in the physical and mechanical behavior. A series of laboratory tests, including the Atterberg limits tests, the unconfined compressive strength tests, direct shear tests in soaked and unsoaked conditions, swelling tests, and odometer tests, were conducted on untreated and treated soils with synthesized polymers. The results showed a salient enhancement in the cohesion and the unconfined compressive strength value of both soils. However, the polymer with a glass-transition temperature near to ambient temperature led to a greater increase in the compressive and shear strength of stabilized soil among its peers. Samples treated with the polymer having the lowest glass transition temperature revealed a more compression index (i.e., obtained from odometer tests) and lower unconfined compressive strength. It is also observed that the swelling index and swelling pressure decreased marginally with increasing the glass transition temperature. [ABSTRACT FROM AUTHOR]

The purpose of this study is to evaluate the adequacy of the 100-year discharge along with the Froehlich bridge abutment scour equation adopted by the U.S. Federal Highway Administration (FHwA) in predicting abutment scour for bridge design purposes in South Carolina streams. The analysis utilized bridge properties, stream cross-sectional and hydraulic data, local flood frequency equations, a one-dimensional steady river flow computer model (WSPRO), and procedures recommended by the FHwA for predicting abutment scour. A method was developed to identify the single stream-discharge at each bridge that can cause the abutment scour that was observed at 73 bridge abutments. Analysis of the results revealed that for one-third of the abutments in the sandy soil region of South Carolina, the flow rates required to produce the observed scour depths had return periods greater than 100 years. Although for bridges in the region dominated by clay soil, the return periods were significantly smaller than 100 years. [ABSTRACT FROM AUTHOR]

The laboratory and field test data on the response of piles under the combined action of vertical and lateral loads is rather limited. The current practice for design of piles is to consider the vertical and lateral loads independent of each other. This paper presents some results from three-dimensional finite-element analyses that show the significant influence of vertical loads on a pile’s lateral response. The analyses were performed in both homogeneous clayey soils and homogeneous sandy soils. The results have shown that the influence of vertical loads on the lateral response of piles is to significantly increase the capacity in sandy soils and marginally decrease the capacity in clayey soils. In general, it was found that the effect of vertical loads in sandy soils is significant even for long piles, which are as long as 30 times the pile width, while in the case of clayey soils, the effect is not significant for piles beyond a length of 15 times the width of the pile. The design bending moments in the laterally loaded piles were also found to be dependent on the level of vertical load on the piles. [ABSTRACT FROM AUTHOR]

This paper examines the validity of the plasticity index (PI) as a criterion for estimating the liquefaction potential of clayey soils under cyclic loading. The results of undrained cyclic stress-controlled ring-shear tests on artificial mixtures of sand with different clays saturated with water indicated that an increase in PI decreased the soil potential to liquefy, and soil with PI>15 seemed to be nonliquefiable, a finding that is in agreement with the results of other researchers. However, in this study some deviations from this relation were found when a bentonite–sand mixture was treated with solutions of different ions, thus bringing into question the effectiveness of PI as a measure of the liquefaction potential of clayey soil having a certain pore water chemistry. [ABSTRACT FROM AUTHOR]