Search

Clothing can absorb fine particulate pollutants from the atmosphere outdoors and then release them after entering the room in a form similar to three-handed smoke. In this study, the experimental site in Zhengzhou, a typical city with heavy pollution in central China, was used to investigate the adsorption and diffusion patterns of three different fabrics of polyester, polyester-cotton, and cotton clothing for fine particle pollutants, to guide people's behavior patterns and indoor air distribution, and to reduce indoor pollution exposure. The results showed that when garments of three different fabrics were exposed to moderate and heavy PM2.5 pollution for 1 h, 2 h, and 3 h, respectively, and then transferred to the diffusion chamber, polyester always released the highest PM2.5 concentration to indoor air during the same release cycle, followed by cotton and polyester-cotton. In addition, the concentration of indoor air pollutants will be periodically affected by the diffusion of fine particulate adsorbed by clothing fabrics. With the increase in outdoor pollution and exposure duration, the indoor PM2.5 concentration takes longer to stabilize at certain levels after the clothing is transferred to the indoor side. Finally, the comparison of natural ventilation experiments proved that it is not feasible to rely solely on natural ventilation to improve the influence of clothing pollution sources on indoor air quality. [ABSTRACT FROM AUTHOR]

Phase change materials (PCMs) are recognized as a promising passive energy retrofit technology for existing buildings, as they are applied to the internal and external surfaces of the building with less impact on the original structure. However, the effectiveness of PCMs varies from region to region. Taking the Central Plains of China as an example, this paper investigated the effect of phase change temperature and material thickness variation on the energy efficiency of PCM when it was arranged on 14 placements including furniture through EnergyPlus (E+). And further explored the applicability of coupling PCMs with natural ventilation (NV). The results showed that: for the Central Plains of China, PCMs arranged on the internal surface of building roofs were optimal, and the reduction rate of uncomfortable degree hours could reach 38%, 26%, 24% and 40% after integrating PCMs into the roof, floor, external wall and furniture. The uncomfortable degree hour reduction rate per unit mass of PCM was 0.052%/kg for the roof, and the value of furniture was very close to the external wall and floor, which achieved 0.033%/kg. In addition, the coupling of PCM with NV improved the energy efficiency of PCM by more than twice. [ABSTRACT FROM AUTHOR]