Search

Gunshot wound analysis is an important part of medicolegal practice, in both autopsies and examinations of living persons. Well-established and studied simulants exist that exhibit both physical and biomechanical properties of soft-tissues and bones. Current research literature on ballistic wounds focuses on the biomechanical properties of skin simulants. In our extensive experimental study, we tested numerous synthetic and natural materials, regarding their macromorphological bullet impact characteristics, and compared these data with those from real bullet injuries gathered from medicolegal practice. Over thirty varieties of potential skin simulants were shot perpendicularly, and at 45°, at a distance of 10 m and 0.3 m, using full metal jacket (FMJ) projectiles (9 × 19 mm Luger). Simulants included ballistic gelatine at various concentrations, dental silicones with several degrees of hardness, alginates, latex, chamois leather, suture trainers for medical training purposes and various material compound models. In addition to complying to the general requirements for a synthetic simulant, results obtained from dental silicones shore hardness 70 (backed with 20 % by mass gelatine), were especially highly comparable to gunshot entry wounds in skin from real cases. Based on these results, particularly focusing on the macroscopically detectable criteria, we can strongly recommend dental silicone shore hardness 70 as a skin simulant for wound ballistics examinations. [ABSTRACT FROM AUTHOR]

Computed tomography (CT) may have a crucial role in the forensic documentation and analysis of firearm injuries. The aim of this forensic ballistics case study was to explore whether two types of expanding bullets and a full metal-jacketed bullet could be differentiated by inspecting bullet fragments and fragmentation pattern in CT. Three types of.30 caliber bullets (full metal-jacketed Norma Jaktmatch, expanding full-copper Norma Ecostrike, and expanding soft-point Norma Oryx) were test fired from a distance of 5 m to blocks of 10% ballistic gelatine. CT scans of the blocks were obtained with clinical equipment and metal artifact reduction. Radiopaque fragments were identified and fragmentation parameters were obtained from the scans (total number of fragments, maximum diameter of the largest fragment, distance between entrance and the closest fragment, length of the fragment cloud, and maximum diameters of the fragment cloud). The fragmentation patterns were additionally visualized by means of 3D reconstruction. In CT, the bullet types differed in several fragmentation parameters. While the expanding full-copper bullet Ecostrike left behind only a single fragment near the end of the bullet channel, the soft-point Oryx had hundreds of fragments deposited throughout the channel. For both expanding bullets Ecostrike and Oryx, the fragments were clearly smaller than those left behind by the full metal-jacketed Jaktmatch. This was surprising as the full metal-jacketed bullet was expected to remain intact. The fragment cloud of Jaktmatch had similar mediolateral and superoinferior diameters to that of Oryx; however, fragments were deposited in the second half of the gelatine block, and not throughout the block. This case study provides a basis and potential methodology for further experiments. The findings are expected to benefit forensic practitioners with limited background information on gunshot injury cases, for example, those that involve several potential firearms or atypical gunshot wounds. The findings may prove beneficial for both human and wildlife forensics. [ABSTRACT FROM AUTHOR]

The wounding potential of a projectile depends on its kinetic energy. The aim of the study was to investigate the deceleration of non-deforming full metal jacket handgun bullets (FMJ) in gelatine blocks of increasing length. The temporary cavity (TC) was visualized using a SA-X2 Photron camera. 126 test shots in 9 mm nominal calibre were fired under strict temperature control conditions (4°C) at small gelatine blocks ranging from 2 to 12 cm in length. The deposited energy was calculated based on the loss of bullet velocity through high-speed video analysis. The length of the TC was measured, when the TC reached its maximum height. The volume of the TC was approximated by a cylinder. Regression analysis showed a linear correlation between the length of the bullet path and the energy transfer. The constant deceleration of the FMJ bullets in gelatine up to 12 cm bullet path was confirmed across various brands and velocity ranges (270–450 m/s). Higher impact velocities correlated with increased loss of energy in the target medium. The shape of the bullet tip influenced the characteristic of deceleration. The volume of the tubular temporary cavity, derived from high-speed video records, was found to be proportional to the energy transferred. The proposed approach might be a valuable tool in advancing wound ballistics research. • Deceleration of FMJ bullets proportional to bullet path in compact target models. • Higher impact velocities resulted in greater loss of energy in the target medium. • The shape of the bullet tip influenced the characteristic of deceleration. • Proportionality of the temporary cavity to the transferred energy. [ABSTRACT FROM AUTHOR]