Search

Abstract: This study investigated the impact of olive mill wastewater (OMW) as a pollutant of the marine environment, via the detection of stress indice alterations in mussels Mytilus galloprovincialis. Due to the absence of data concerning the levels of OMW in the receiving waters, mortality test (96h) was first performed in order to estimate the range of OMW concentration where no mortality occurs. OMW concentrations ranging from 0.01 to 0.1% (v/v) showed no increased mortality and thus were used for the determination of pre-pathological alterations in tissues of mussels. In particular, mussels exposed to either 0.1 or 0.01% (v/v) OMW for 5 days showed significant alterations of stress indices in their tissues. Specifically, decreased neutral red retention (NRR) assay time values, inhibition of acetylcholinesterase (AChE) activity, as well as a significant increase of micronucleus (MN) frequency and DNA damage were detected in haemolymph/haemocytes and gills, compared with values measured in tissues of control mussels. The results of the present study showed that OMW disposal into the marine environment could induce pre-pathological alterations in marine organisms, before severe disturbances, such as disease, mortality, or population changes occur. [ABSTRACT FROM AUTHOR]

This study focuses on investigating sugar recovery from spoiled date fruits (SDF) for sustainable ethanol production using newly isolated yeasts. Upon their isolation from different food products, yeast strains were identified through PCR amplification of the D1/D2 region and subsequent comparison with the GenBank database, confirming isolates KKU30, KKU32, and KKU33 as Saccharomyces cerevisiae; KKU21 as Zygosaccharomyces rouxii; and KKU35m as Meyerozyma guilliermondii. Optimization of sugar extraction from SDF pulp employed response surface methodology (RSM), varying solid loading (20–40%), temperature (20–40 °C), and extraction time (10–30 min). Linear models for sugar concentration (R1) and extraction efficiency (R2) showed relatively high R2 values, indicating a good model fit. Statistical analysis revealed significant effects of temperature and extraction time on extraction efficiency. The results of batch ethanol production from SDF extracts using mono-cultures indicated varying consumption rates of sugars, biomass production, and ethanol yields among strains. Notably, S. cerevisiae strains exhibited rapid sugar consumption and high ethanol productivity, outperforming Z. rouxii and M. guilliermondii, and they were selected for scaling up the process at fed-batch mode in a co-culture. Co-cultivation resulted in complete sugar consumption and higher ethanol yields compared to mono-cultures, whereas the ethanol titer reached 46.8 ± 0.2 g/L. [ABSTRACT FROM AUTHOR]

As an easily obtained organic waste, by-product acetic acid could be an appropriate co-substrate with blue algae wastes (increase C/N ratio of substrates) for co-fermentation of PHA production. However, there are still acrylic acid and other chemicals in by-product acetic acid, which could cause severe inhibition for fermenting microorganisms during PHA production process. The current study represented that alkali pretreatment (pH level of 12) is a more favorable method compared with thermal pretreatment (80 ℃ for 30 min) for breaking cell walls of blue algae. It seemed that there was no synergistic effect of the combination of thermal and alkali pretreatment methods (temperature of 80 ℃ and pH level of 12). Optimal parameters during electro-fenton process for removal of inhibitors in by-product acetic acid were under current of 0.5 A, pH level of 3 and reaction time of 120 min. Both the highest dry weight of PHA and PHA concentration were achieved by applying blue algae and by-product acetic acid (after pretreatment) as co-substrates (mixed ratio of 3:1, stirring speed of 200 r/min, 24 h), indicating that using by-product acetic acid (after pretreatment) as co-substrate could increase C/N ratio and promote PHA production successfully. The current study could offer new insights for improving PHA production by co-fermentation. [Display omitted] • Alkali pretreatment is a more favorable method compared with thermal pretreatment. • There was no synergistic effect of the combination of thermal and alkali pretreatment. • Optimal parameters for removal of inhibitors in by-product acetic acid were determined. • By-product acetic acid (after pretreatment) as co-substrate could promote PHA production. [ABSTRACT FROM AUTHOR]

The effect of different pretreatment approaches based on alkali (NaOH)/hydrogen peroxide (H2O2) on willow sawdust (WS) biomass, in terms of delignification efficiency, structural changes of lignocellulose and subsequent fermentation toward ethanol, was investigated. Bioethanol production was carried out using the conventional yeast Saccharomyces cerevisiae, as well as three non-conventional yeasts strains, i.e., Pichia stipitis, Pachysolen tannophilus, Wickerhamomyces anomalus X19, separately and in co-cultures. The experimental results showed that a two-stage pretreatment approach (NaOH (0.5% w/v) for 24 h and H2O2 (0.5% v/v) for 24 h) led to higher delignification (38.3 ± 0.1%) and saccharification efficiency (31.7 ± 0.3%) and higher ethanol concentration and yield. Monocultures of S. cerevisiae or W. anomalus X19 and co-cultures with P. stipitis exhibited ethanol yields in the range of 11.67 ± 0.21 to 13.81 ± 0.20 g/100 g total solids (TS). When WS was subjected to H2O2 (0.5% v/v) alone for 24 h, the lowest ethanol yields were observed for all yeast strains, due to the minor impact of this treatment on the main chemical and structural WS characteristics. In order to decide which is the best pretreatment approach, a detailed techno-economical assessment is needed, which will take into account the ethanol yields and the minimum processing cost. [ABSTRACT FROM AUTHOR]

The scope of the current study was to investigate the efficiency of a two-stage anaerobic-aerobic process for the simultaneous treatment and valorization of selective wastewater streams from a confectionary industry. The specific wastewater (confectionary industry wastewater, CIW) was a mixture of the rinsing eluting during washing of the cauldrons in which jellies and syrups were produced, and contained mainly readily fermentable sugars, being thus of high organic load. The first stage of the process was the dark fermentation (DF) of the CIW in continuous, attached-biomass systems, in which the effect on hydrogen yields and distribution of metabolites were studied for different packing materials (ceramic or plastic), hydraulic retention times, HRTs (12 h–30 h) and feed substrate concentration (20 g COD/L- 50 g COD/L). In the second stage, the effectiveness of the aerobic treatment of the DF effluents was evaluated in terms of the reduction of the organic load and the production of polyhydroxyalkanoates (PHAs) through an enriched mixed microbial culture (MMC). The MMC was developed in a continuous draw and fill system, in which the accumulation potential of PHAs was studied. It was shown that the hydrogen production rates decreased for increasing substrate concentration and HRTs, with a maximum of 12.70 ± 0.35 m3 H 2 /m3 initial CIW achieved for the lowest HRT and feed concentration and using ceramic beads as packing material. Butyrate, acetate and lactate were the main metabolites generated in all cases, in different ratios. The distribution of metabolites during DF was shown to highly affect the efficiency of the second process in terms of both the reduction of organic load and the PHAs yields. The highest removal of organic load achieved after 48 h of aerobic treatment was 84.0 ± 0.9 %, whereas the maximum PHAs yield was 21.46 ± 0.13 kg PHAs/m3 initial CIW. • The simultaneous treatment and valorization of confectionary wastewater was assessed via an anaerobic-aerobic process. • The operational optimization of the anaerobic stage and the biocatalysts of the aerobic stage are equally important. • The hydrogen yields and distribution of the metabolites are mainly affected by the feeding strategy. • Up to 12.70 ± 0.35 m3 H 2 /m3 initial wastewater and 21.46 ± 0.13 kg PHAs/m3 initial wastewater were produced. • Efficient reduction up to ∼90% of its organic load was achieved by the two stage process. [ABSTRACT FROM AUTHOR]

In this study fungal pretreatment of willow sawdust (WSD) via the white rot fungi Leiotrametes menziesii and Abortiporus biennis was studied and the effect on fractionation of lignocellulosic biomass and biochemical methane potential (BMP), was evaluated. Scanning electron microscopy (SEM) and IR spectroscopy were used to investigate the changes in the structural characteristics of the pretreated WSD. Fungal pretreatment results revealed that A. biennis is more attractive, since it resulted in higher lignin degradation and lower holocellulose uptake. Samples of the 14th and 30th d of cultivation (i.e. the middle and the end of the pretreatment experiment) with both fungi were used for BMP tests and the effect of pretreatment duration was also evaluated. BMP increase by 31 and 43% was obtained due to the cultivation of WSD with A. biennis , for 14 and 30 d, respectively. In addition, combination of biological (after 30 d of cultivation) with alkaline (NaOH 20 g/100 gTS) pretreatment was performed, in order to assess the effect of the chemical agent on biologically pretreated WSD, in terms of lignocellulosic content and BMP. Combination of alkaline with fungal pretreatment led to high lignin degradation for both fungi, while the cellulose and hemicellulose removal efficiencies were higher for combined alkaline and L. menziesii pretreatment. The maximum BMP was observed for the combined alkaline and A. biennis pretreatment and was 12.5 and 50.1% higher than the respective alkaline and fungal pretreatment alone and 115% higher than the respective BMP of raw WSD. [ABSTRACT FROM AUTHOR]

PHAs are a form of cellular storage polymers with diverse structural and material properties, and their biodegradable and renewable nature makes them a potential green alternative to fossil fuel-based plastics. PHAs are obtained through extraction via various mechanical, physical and chemical processes after their intracellular synthesis. Most studies have until now focused on pure cultures, while information on mixed microbial cultures (MMC) remains limited. In this study, ultrasonic (US) disruption and alkaline digestion by NaOH were applied individually and in combination to obtain PHAs products from an acclimated MMC using phenol as the carbon source. Various parameters were tested, including ultrasonic sound energy density, NaOH concentration, treatment time and temperature, and biomass density. US alone caused limited cell lysis and resulted in high energy consumption and low efficiency. NaOH of 0.05–0.2 M was more efficient in cell disruption, but led to PHAs degradation under elevated temperature and prolonged treatment. Combining US and NaOH significantly improved the overall process efficiency, which could reduce energy consumption by 2/3rds with only minimal PHAs degradation. The most significant factor was identified to be NaOH dosage and treatment time, with US sound energy density playing a minor role. Under the semi-optimized condition (0.2 M NaOH, 1300 W L-1, 10 min), over 70% recovery and 80% purity were achieved from a 3 g L−1 MMC slurry of approximately 50% PHAs fraction. The material and thermal properties of the products were analyzed, and the polymers obtained from US + NaOH treatments showed comparable or higher molecular weight to previously reported results. The products also exhibited good thermal stability and rheological properties, compared to the commercial standard. In conclusion, the combined US and NaOH method has the potential in real application as an efficient process to obtain high quality PHAs from MMC, and cost-effectiveness can be further optimized. [Display omitted] • Ultrasonic (US) and alkaline digestion used to recover PHB from a mixed culture. • US disruption had limited effect of cell lysis and high energy consumption. • NaOH digestion was more efficient but led to PHA degradation under high temperature. • US + NaOH showed synergetic effect, reduced treatment time and energy consumption. • US + NaOH can be cost-effective after optimization, showing potential of scaling-up. [ABSTRACT FROM AUTHOR]

Given that the social and economic sustainability of rural areas is highly based on the protection of natural resources, biodiversity and human health, simple-operated and cost-effective wastewater treatment systems, like artificial constructed wetlands (CWs), are widely proposed for minimizing the environmental and human impact of both water and soil pollution. Considering that the optimization of wastewater treatment processes is vital for the reduction of effluents toxic potential, there is imperative need to establish appropriate management strategies for ensuring CW performance and operational efficiency. To this end, the present study aimed to assess the operational efficiency of a horizontal free water surface CW (HFWS-CW) located in a world heritage area of Western Greece, via a twelve-month duration Toxicity Identification Evaluation (TIE)-like approach, including both chemical and biological tracking tools. Conventional chemical tracking, by means of pH, conductivity, total COD, and nitrogen-derived components, like nitrates and ammonia–nitrogen, were monthly recorded in both influents and effluents to monitor whether water quality standards are maintained, and to assess potent CW operational deficiencies occurring over time. In parallel, Whole Effluent Toxicity (WET) bioassays were thoroughly applied, using freshwater algae and higher plant species (producers), crustaceans and rotifers (consumers), as well as human lymphocytes (in terms of Cytokinesis Block Micronucleus assay) to evaluate the acute and short-term toxic and hazardous potential of both influents and effluents. The integrated analysis of abiotic (physicochemical parameters) and biotic (toxic endpoints) parameters, as well as the existence of "cause-effect" interrelations among them, revealed that CW operational deficiencies, mainly based on poorly removal rates, could undermine the risk posed by treated sewage. Those findings reinforce the usage of WET testing, thus giving rise to the importance of applying appropriate water management strategies and optimization actions, like oxygen enrichment of surface and bottom of HFWS-CW basins, expansion of the available land, the enhancement of bed depth and seasonal harvesting of plants, for ensuring sewage quality, in favor of water resources protection and sustainable growth in rural areas. [Display omitted] • Constructed wetland (CW) performance was recorded via a TIE-like approach. • Whole effluent toxicity (WET) testing and chemical tracking were performed. • Chemical tracking in poorly operated CWs could undermine the risk of treated sewage. • TIE-like approach, including biological tracking, improves the CW performance. • Integrating abiotic and WET data could favor CW optimization and water management. [ABSTRACT FROM AUTHOR]