Search

Nanomaterials are integrated within consumer products to enhance specific properties of interest. Their release throughout the lifecycle of nano-enabled products raises concerns; specifically, mechanical strains can lead to the generation of fragmented materials containing nanomaterials. We investigated the potential release of single-walled carbon nanotubes (SWCNTs—brand TUBALL™) from epoxy composite materials. A pin-on-disk-type tribometer was used for the accelerated mechanical aging of the nanocomposites. A pristine nanocomposite material, abraded material and debris obtained from the abrasion in the tribometer were analyzed by Raman spectroscopy. The airborne-produced particles were captured using particle collectors. Stat Peel's Identifier C2 system was used to monitor the SWCNT content of respirable particles produced during the abrasion test. The SWCNT amounts found were below the LoQ. The Raman spectra conducted on the Stat Peel filters helped identify the presence of free SWCNTs released from the epoxy matrix, although they were notably scarce. Raman spectroscopy has been proved to be a crucial technique for the identification, characterization and assessment of structural changes and degradation in SWCNTs that occurred during the abrasion experiments. [ABSTRACT FROM AUTHOR]

The detection of the highly toxic per- and polyfluoroalkyl substances, PFAS, constitutes a challenging task in terms of developing a generic method that could be rapid and applicable simultaneously to both long and short-chain PFAS at ppt concentration level. In the present study, the method introduced by the USA Environmental Protection Agency, EPA, to detect surfactants, using methylene blue, MB, which is identified an ideal candidate for PFAS-MB ion pairing, is extended at the lowest concentration range by a simple additional step that involves the dissociation of the ion pairs in water. In this work, Surface Enhanced Raman Scattering, SERS, is applied via Ag nanocolloidal suspensions to probe MB and indirectly either/or both short-chain (perfluorobutyric acid, PFBA) and long-chain (perfluoloctanoic acid, PFOA) PFAS downt to 5 ppt. This method, which can be further optimized to sub-ppt level via a custom-made SERS-PFAS dedicated Raman system, offers the possibility to be applied to either specific PFAS (both short and long-chain) in a targeted analysis or to total PFAS in a non-targeted analysis at very low detection limits, following any type of MB detection method in aqueous solutions and obviously with any type of SERS substrate. [Display omitted] • Generic PFAS detection method applicable to both short and long chain PFAS. • SERS method achieved LOD down to 5 ppt of PFAS. • Ion pairing between PFAS-MB triggered the process. • Dissociation of the ion pairs resulted the better LODs. [ABSTRACT FROM AUTHOR]