Search

This study examined the pattern of resistance to widely applied synthetic pyrethroids, i.e., cypermethrin and deltamethrin, against larvae of Rhipicephalus microplus ticks sampled from Marathwada region in Maharashtra, India. The study also examined the role of α- and β-esterases and glutathione-S-transferase (GST) in resistance development. All eight R. microplus isolates tested were resistant to deltamethrin (RL IV), having RR50 values from 6.88 to 131.26. LPT analysis exhibited the resistance level II deltamethrin resistance in Beed and Hingoli, III in Dharashiv, and IV in Sambhajinagar, Parbhani, Latur, Jalna, and Nanded isolates. The LIT analysis showed that Dharashiv field isolates had the lowest LC50 value of 229.09 ppm against cypermethrin, while Sambhajinagar field isolates had the highest at 489.78 ppm. The RR50 ranged from 1145.45 to 2448.9. Seven isolates were level I resistant to cypermethrin while the Jalna isolate was level II resistant. In larvae treated with deltamethrin and cypermethrin, the activity of α- and β-esterase enzymes increased significantly compared to control groups. The enzyme ratios in treated larvae ranged from 0.7533 to 1.7023 for α-esterase and 0.7434 to 3.2054 for β-esterase. The Hingoli isolate treated with cypermethrin exhibited the highest α-esterase activity (903.261), whereas Sambhajinagar isolate had the highest GST enzyme ratio (2.8224) after deltamethrin exposure. When exposed to cypermethrin, the Hingoli isolate showed the highest GST enzyme ratio, 2.0832. The present study provides the current resistance status in tick populations from Marathwada region indicating deltamethrin and cypermethrin to be ineffective for tick control. The results also suggest that SP compounds should be regulated in this region and alternative control strategies should be introduced. [ABSTRACT FROM AUTHOR]

In the present study, the crude aqueous and chloroform extracts of Annona squamosa was tested for its in-vitro acaricidal efficacy against Rhipicephalus microplus ticks. Concentrations of 2.5%, 5%, 7.5%, 10% and 12.5% were tested against adult ticks whereas 0.312%, 0.625%, 1.25% and 2.5% were tested against larvae. No significant mortality and effect on oviposition was observed using aqueous extract, however, chloroform extract showed strong activity against both viz. adults and larvae. The highest adult mortality was observed at 12.5% concentration and determined LC50 and LC90 values were 5.24% and 14.12% respectively. A dose dependent reduction in egg laying capacity of treated female was observed in all concentrations compared to control group. The recorded mean mortality of larvae was 13.45 ± 0.73, 71.04 ± 1.10, 98.28 ± 0.39 and 100 ± 0.00 observed at 0, 0.312%, 0.625%, 1.25% and 2.5% of concentrations respectively. [ABSTRACT FROM AUTHOR]

Industrial waste locks are used as raw materials to reduce harmful effects on the environment and improve environmental performance. Marble clay powder can be used as a filling aid and can fill voids in concrete structures. This article will show you how to use a maximum natural sand alternative in concrete with marble powder and quarry dust. The challenge of the 21st century is to change to a new form that can support the natural system. This necessitates a radical rethinking of how to give the community infrastructure and housing. Making a concerted effort to develop novel, innovative, and alternative construction materials may be necessary. Jungles of concrete around cause's impact on the Environment and it would result in climate change. Mankind must avoid the use of things that are detrimental to the environment. So in this paper, it is decided to address the issue by adopting the use of the green concrete concept which is environmentally friendly. Green concrete is concrete made up using industrial wastes such as marble powder, quarry dust, wood ash, paper pulp, etc. Green concrete, which is capable of sustainable development, helps to reduce the consumption of natural resources, energy use, and environmental pollution. Green concrete is more cost‐effective than ordinary concrete and reduces the cost of resultant concrete by 14%–20%. It is also observed that the alkali‐aggregate reaction and sulfate attack resistance of concrete are both significantly improved. Green concrete is a useful tool for lowering environmental pollution and enhancing concrete's resistance to harsh conditions. All stages of infrastructure construction and rehabilitation will follow this trend of using new cement and techniques. Green concrete's adaptability and its performance derivatives will meet a variety of future needs. [ABSTRACT FROM AUTHOR]

Corrosion is the irreversible, interfacial reaction of metals in the presence of an electrochemical environment which ultimately results in the deterioration of metals. Corrosion of reinforcement is the major problem in the reinforced concrete (RC) structure. Corrosion of reinforcement is a slow process because of the protective layer of concrete. Even in a severely corrosive environment corrosion process takes time to be initiated and propagated. Since to carry out research work, some techniques are required to accelerate the corrosion process in the shortest period. To overcome this problem, in the past, many researchers use a different method to accelerate the corrosion of steel in concrete. In this paper, a review is presented of various techniques used for accelerated corrosion testing. The suitability of reviewed methods on corrosion acceleration for several research works is presented. After that few case studies review to make use of various predicted empirical models and an experimental technique for predicting corrosion rate and the assessment of the remaining life of the structure. And finally, the paper is concluded by comparing the natural method of corrosion and the accelerated method of corrosion and the future scope of accelerated corrosion. [ABSTRACT FROM AUTHOR]

The use of ordinary Portland cement (OPC) in the construction industry is inevitable. The huge production of OPC and its use in infrastructural development pose an environmental impact. Greenhouse gas emitted increases the global temperature and it is an alarming sign to everybody on the planet. Concrete is the most consuming material which is produced by using OPC and it is proven that OPC contributes a lot to CO2 emission. Hence in this study attempt is made to produce concrete by using environment‐friendly material like fly ash along with alkaline activators, which is termed Geo polymer concrete. The by‐product fly ash is widely available worldwide. It is a by‐product of thermal power plants. The use of fly ash in concrete produces less expensive and more cost‐effective concrete than concrete made up using OPC. Due to its high silicate and alumina content, fly ash reacts with an alkaline solution to create an aluminosilicate gel that binds the aggregate and results in high‐quality concrete. Fly ash is finer than cement, it occupies the pores of cement after hydration. This would result in denser concrete which gives higher strength. In comparison to ordinary concrete, fly ash‐based geopolymer concrete offers better resistance to aggressive environments and high temperatures. In the present study, an alkaline activator of molarity 8 is used to prepare geopolymer concrete. The test specimens are cast and cured for 28 days. Test results indicate that an alkaline liquid fly‐ash ratio (0.4) produces higher mechanical properties. Hence, geopolymer concrete produced in this study is found to be cost‐effective and environment friendly. [ABSTRACT FROM AUTHOR]

The study was conducted to evaluate two anaesthetic protocols in 12 clinical cases of dogs presented to Veterinary Clinical Complex, COVAS, Parbhani for elective surgeries. These cases were divided into two equal groups (n=6). In both groups, dogs were pre-medicated with inj. Xylazine @ 1 mg/kg intramuscularly and anaesthesia was induced with inj. Tiletamine-Zolazepam (2 mg/kg) intravenously. Anaesthesia was maintained on constant rate infusion (CRI) of Tiletamine-Zolazepam (@ 2 mg/kg/h) in the dogs of group 1 and on Isoflurane in the dogs of group 2. Anaesthesia was assessed based on the quality of induction and recovery time in both groups. Clinico-physiological and haemato-biochemical parameters were measured in both groups at 5 different intervals. The induction score was identical in both groups with prolonged recovery in group 1. Clinico-physiological and haemato-biochemical values were changed from the base line value and return towards the baseline at recovery in both groups. [ABSTRACT FROM AUTHOR]

Background and Aim: Dexamethasone, a glucocorticoid, has been used in local anesthetics as an additive for various locoregional nerve blocks. Although, its use in the dental field has not been unexplored and concealed. The current study was conducted to evaluate and compare the calibre of anesthesia, their hemodynamic response, vasoconstrictive effects, and control of pain while administering pterygomandibular nerve blocks using 2% Lignocaine hydrochloride solution with Dexamethasone(4mg/ml) with that of the standard 2% Lignocaine hydrochloride solution and Adrenaline bitartrate (1:80000). Materials and Methods: This triple-blind randomized controlled study included 80 healthy subjects, aged between 18-45 years with an indication for surgical removal of impacted mandibular third molars. With the aid of a computer-generated sequence, the subjects were arbitrarily assigned into 2 groups (40/group)- Group 1: patients administered with 2% Lignocaine hydrochloride and Dexamethasone Sodium Phosphate (4mg/ml) solution, and Group 2: patients administered with 2% Lignocaine hydrochloride with Adrenaline bitartrate (Adr) 1: 80,000 (12.5 µgm/ml) solution. The variables were assessed based on their time of onset, depth (pain) and duration of anesthesia, systolic, diastolic, and mean arterial blood pressures, heart rate, and blood loss. Results: Statistically significant difference (P<0.05) was noticed for the onset (shorter onset in Group 1) and duration of action (prolonged in group 1) and number of analgesics required (less in grp 1). Statistically non-significant difference between 2 groups (P>0.05) for pain, blood loss, cardiovascular variables (systolic, diastolic and mean arterial blood pressures and heart rate) at various intervals was noted. Conclusion: Dexamethasone added to Lignocaine shortens onset, prolongs duration of action and yields better control of post-operative pain as compared to Lignocaine with Adr. Vasoconstrictive properties, hemodynamic variables and intra-op pain control were comparable. [ABSTRACT FROM AUTHOR]