Search

The Soil Moisture Active Passive (SMAP) mission includes a unique combination of instruments intended to provide daily global soil moisture data with high accuracy and resolution. Due to radar instrument failure, the default resolution of the data product decreased from the intended 9 km to 36 km shortly after the mission started to return data. To improve this, we employed the Scatterometer Image Reconstruction algorithm in its radiometer form (rSIR) to enhance the resolution of the radiometer brightness temperature measurements from which the soil moisture was derived. This paper compares the soil moisture estimates created from the rSIR-enhanced brightness temperatures with SMAP project radiometer L2_SM_SP and SMAP-Sentinel L2_SM_P products reported on 9 km and 3 km grids, respectively. We find that the difference of the rSIR-enhanced passive soil moisture product is generally within 0.020 cm 3 cm − 3 RMS of the 9 km SMAP radiometer L2_SM_SP and 0.045 cm 3 cm − 3 RMS of the 3 km SMAP-Sentinel L2_SM_P soil moisture products. The accuracy of the rSIR soil moisture can be improved by including better antenna pattern correction methods applied to the input TB measurements. [ABSTRACT FROM AUTHOR]

This paper presents measurements using a dual-polarised radiometer operating at 93 GHz to detect ice or water on asphalt in laboratory conditions. The brightness temperatures of both H and V polarizations were measured for a dry surface, liquid water, and ice on asphalt at observation angles of 50° and 56°. The results presented in this paper demonstrate that the studied road conditions can be identified by the radiometer. The measurements are compared with a model and surface parameters, such as dielectric constant and roughness are fitted and compared to reference values. The experiments and results, described in this article, are the first steps towards the future installation of a polarimetric sensor on a moving vehicle for traffic safety. [ABSTRACT FROM AUTHOR]

L-band brightness temperature (TB) has been shown to provide the best sensitivity to soil moisture (SM) although C- and X-band based products offer a longer time-series from satellite-based measurements. Currently, global coverage SM is routinely produced from spaceborne measurements using all three frequency bands, but despite continued validation efforts of the products, the relative characteristics and performance of these observations have not been fully established. Therefore, this study focused on the parametrization of SM retrieval algorithms at L-, C- and X-bands using TB observations from the L-band radiometer on NASA's SM Active Passive (SMAP) mission and the C- and X-band channels of JAXA's Advanced Microwave Scanning Radiometer 2 (AMSR2) onboard the GCOM-W satellite. These can be applied in global SM retrieval algorithms using either one of the frequencies or a combination of them. The reference in situ SM data was obtained from 12 core validation sites across various land cover types around the world. The investigation highlighted the known challenges of retrieving SM from C- and X-band data compared to the higher sensitivity of the L-band data. Even with a site-specific retrieval algorithm parameterization, the mean correlation of the C- and X-band retrievals for the core validation site SM measurement were much lower than that for L-band, being 0.52 (0.54) and 0.45 (0.47) for vertical (horizontal) polarization, respectively, while for the L-band retrieval the corresponding values were 0.81 (0.77). The parameterization exercise showed that matching the C- and X-band TB measurements with an emission model was not difficult; the problem was relating the observations to SM under the influence of large roughness and vegetation effects. As a result, parameter optimization produced values for some sites that were not realistic or did not allow any practical sensitivity to SM at C- and X-band. Considering the L-band observations, the parameter optimization resulted in superior bias performance as compared to the operational SMAP product parameterization, but the sensitivity to SM changes (R and unbiased root mean square difference) did not improve markedly, or in some cases degraded at the expense of a smaller bias. • Spaceborne radiometer observation at L/C/X-band over 12 soil moisture core sites. • Calibration of soil moisture retrieval algorithm for L/C/X-band using the core sites. • L-band retrieval achieves correlation of 0.8 while C/X-band achieves only 0.5. • Retrieval capability of C/X-band questionable over some of the sites. • Calibration of L-band improves bias and RMSD over SMAP product but not sensitivity. [ABSTRACT FROM AUTHOR]

In the TOPSAR acquisition mode, Sentinel-1 sensors acquire some data in passive mode, with a periodicity of approximately one second. These data provide valuable information about scene brightness and Radio Frequency pollution. This paper reviews the method to extract these passively sensed data and identify Radio Frequency Interferences (RFI). Two sets of measurements are generated by back-projecting passively sensed data on the ground, generating Earth Brightness Temperature (BT) and RFI equivalent temperature. A proper calibration has been implemented thanks to AMSR-2 data. The paper shows the result of one year of data collection from Sentinel 1 A and B regarding RFI and BT. We discuss the stability of the systems and the accuracy of the measurements by cross-comparing results from the two sensors, and we show how this information can be exploited for precise SAR data denoising and RFI mitigation. • Sentinel-1 TOPSAR mode senses Earth Brightness and Radio Frequency Interferences. • Brightness maps can be generated over most landmasses and nearby sea-ocean. • C-band Radio Frequency emissions can be detected with a sensitivity of hundred of K and continuously monitored World-Wide. • A geometric resolution of kilometers can be achieved by back-projecting ascending and descending passes. • These maps are used to enhance SAR products quality by denoising and removing RFI. [ABSTRACT FROM AUTHOR]