Search

The Soil Moisture Active Passive (SMAP) mission includes a unique combination of instruments intended to provide daily global soil moisture data with high accuracy and resolution. Due to radar instrument failure, the default resolution of the data product decreased from the intended 9 km to 36 km shortly after the mission started to return data. To improve this, we employed the Scatterometer Image Reconstruction algorithm in its radiometer form (rSIR) to enhance the resolution of the radiometer brightness temperature measurements from which the soil moisture was derived. This paper compares the soil moisture estimates created from the rSIR-enhanced brightness temperatures with SMAP project radiometer L2_SM_SP and SMAP-Sentinel L2_SM_P products reported on 9 km and 3 km grids, respectively. We find that the difference of the rSIR-enhanced passive soil moisture product is generally within 0.020 cm 3 cm − 3 RMS of the 9 km SMAP radiometer L2_SM_SP and 0.045 cm 3 cm − 3 RMS of the 3 km SMAP-Sentinel L2_SM_P soil moisture products. The accuracy of the rSIR soil moisture can be improved by including better antenna pattern correction methods applied to the input TB measurements. [ABSTRACT FROM AUTHOR]

Temporal and spatial variation of sea ice type in the Arctic is an indicator of regional and global change. Arctic sea ice can be classified into two major categories: multiyear ice (MYI) and first-year ice. In this paper, classification method based on machine learning is established and applied to produce daily sea ice classification data set during the winter (November–April) from 2002 to 2017 using active microwave data from QuikSCAT and Advanced Scatterometer as well as passive microwave data from Advanced Microwave Scanning Radiometer for EOS, Special Sensor Microwave Imager/Sounder, and Advanced Microwave Scanning Radiometer 2 radiometer. First, the open water area is flagged out using brightness temperature (Tb) from the passive microwave sensor. Then, K-means algorithm is applied to identify the clusters of the two ice types in the Tb/backscatter parameter space and finally assign pixels to each class. Two optimization methods based on the movement of MYI and marginal ice zone are used to correct the misclassification of MYI. The results have shown a decrease of MYI in winter from 2002 to 2017, especially in 2008 and 2013 with a remarkable recovery in 2014. The classifications are consistent with results by visual interpretation from synthetic aperture radar images in the Canadian Arctic Archipelago with overall classification accuracy over 93%. Comparison with classifications from previous studies and products shows that our method could reflect more differences in MYI declining trend interannually and less anomalous fluctuations in certain years. [ABSTRACT FROM AUTHOR]

The paper describes a method of simultaneous measurements of kinematic parameters of a high-speed process by a microwave radio interferometer with a 3-mm range of wavelengths and the brightness temperature of the same process by the microwave radio interferometer operating in the radiometer mode. The methods of radiometer calibration and analysis of radiometric data are described. Results of experimental investigations are reported by an example of measuring the detonation velocity and estimating the brightness temperature of the detonation front in TNT. [ABSTRACT FROM AUTHOR]

In the present paper, permittivity maps of equatorial lunar surface are generated using brightness temperature ( T B ) data obtained from Microwave Radiometer (MRM) of Chang'e-1 and physical temperature ( T P ) data obtained from Diviner of Lunar Reconnaissance Orbiter (LRO). Here, permittivity mapping is not carried out above 60° latitudes towards the lunar poles due to large anomaly in the physical temperature obtained from the Diviner. Microwave frequencies, which are used to generate these maps are 3 GHz, 7.8 GHz, 19.35 GHz and 37 GHz. Permittivity values are simulated using T B values at these four frequencies. Here, weighted average of physical temperature obtained from Diviner are used to compute permittivity at each microwave frequencies. Longer wavelengths of microwave signals give information of more deeper layers of the lunar surface as compared to smaller wavelength. Initially, microwave emissivity is estimated using T B values from MRM and physical temperature ( T P ) from Diviner. From estimated emissivity the real part of permittivity ( ε ), is calculated using Fresnel equations. The permittivity maps of equatorial lunar surface is generated. The simulated permittivity values are normalized with respect to density for easy comparison of simulated permittivity values with the permittivity values of Apollo samples as well as with the permittivity values of Terrestrial Analogue of Lunar Soil (TALS) JSC-1A. Lower value of dielectric constant ( ε ′) indicates that the corresponding lunar surface is smooth and doesn't have rough rocky terrain. Thus a future lunar astronaut can use these data to decide proper landing site for future lunar missions. The results of this paper will serve as input to future exploration of lunar surface. [ABSTRACT FROM AUTHOR]

Microwave radiometer is an effective instrument to monitor the atmosphere continuously in different weather conditions. It measures brightness temperatures at different frequency bands which are subjected to standard retrieval methods to obtain real time profiles of various atmospheric parameters such as temperature and humidity. But the retrieval techniques used by radiometer have to be adaptive to changing weather condition and location. In the present study, three retrieval techniques have been used to obtain the temperature and relative humidity profiles from brightness temperatures, namely; piecewise linear regression, feed forward neural network and neural back propagation network. The simulated results are compared with radiosonde observations using correlation analysis and error distribution. The analysis reveals that neural network with back propagation is the most accurate technique amongst the three retrieval methods utilized in this study. [ABSTRACT FROM AUTHOR]

This paper considers some of the issues of radiometer brightness image formation and reconstruction for use in the NASA-sponsored Calibrated Passive Microwave Daily Equal-Area Scalable Earth Grid 2.0 Brightness Temperature Earth System Data Record project, which generates a multisensor multidecadal time series of high-resolution radiometer products designed to support climate studies. Two primary reconstruction algorithms are considered: the Backus–Gilbert approach and the radiometer form of the scatterometer image reconstruction (SIR) algorithm. These are compared with the conventional drop-in-the-bucket (DIB) gridded image formation approach. Tradeoff study results for the various algorithm options are presented to select optimum values for the grid resolution, the number of SIR iterations, and the BG gamma parameter. We find that although both approaches are effective in improving the spatial resolution of the surface brightness temperature estimates compared to DIB, SIR requires significantly less computation. The sensitivity of the reconstruction to the accuracy of the measurement spatial response function (MRF) is explored. The partial reconstruction of the methods can tolerate errors in the description of the sensor measurement response function, which simplifies the processing of historic sensor data for which the MRF is not known as well as modern sensors. Simulation tradeoff results are confirmed using actual data. [ABSTRACT FROM AUTHOR]

In the present study, the effectiveness of nowcasting convective activities using a microwave radiometer has been examined for Kolkata (22.65° N, 88.45° E), a tropical location. It has been found that the standard deviation of brightness temperature (BT) at 22 GHz and instability indices like Lifting Index (LI), K Index (KI) and Humidity Index (HI) has shown definite changes before convective events. It is also seen that combination of standard deviation of BT at 22 GHz and LI can be most effective in predicting convection. A nowcasting algorithm is prepared using 18 isolated convective events of 2011 and in all cases, a marked variation of these parameters has been seen an hour before the event. Accordingly, a prediction model is developed and tested on convective events of 2012 and 2013. It is seen that the model gives reasonable success in predicting convective rain about 7075 min in advance with a prediction efficiency of 80%. [ABSTRACT FROM AUTHOR]

We present a new high-fidelity method of calibrating a cross-track scanning microwave radiometer using Global Positioning System (GPS) radio occultation (GPSRO) measurements. The radiometer and GPSRO receiver periodically observe the same volume of atmosphere near the Earth's limb, and these overlapping measurements are used to calibrate the radiometer. Performance analyses show that absolute calibration accuracy better than 0.25 K is achievable for temperature sounding channels in the 50-60-GHz band for a total-power radiometer using a weakly coupled noise diode for frequent calibration and proximal GPSRO measurements for infrequent (approximately daily) calibration. The method requires GPSRO penetration depth only down to the stratosphere, thus permitting the use of a relatively small GPS antenna. Furthermore, only coarse spacecraft angular knowledge (approximately one degree rms) is required for the technique, as more precise angular knowledge can be retrieved directly from the combined radiometer and GPSRO data, assuming that the radiometer angular sampling is uniform. These features make the technique particularly well suited for implementation on a low-cost CubeSat hosting both radiometer and GPSRO receiver systems on the same spacecraft. We describe a validation platform for this calibration method, the Microwave Radiometer Technology Acceleration (MiRaTA) CubeSat, currently in development for the National Aeronautics and Space Administration (NASA) Earth Science Technology Office. MiRaTA will fly a multiband radiometer and the Compact TEC/Atmosphere GPS Sensor in 2015. [ABSTRACT FROM PUBLISHER]

Tipping calibration is an important technique for the absolute calibration of ground-based microwave radiometers. The standard tipping calibration is usually used in clear atmosphere. The spatial variations of liquid water in cloudy atmosphere may lead to great calibration errors in the process of standard tipping calibration. A new method of tipping calibration for ground-based microwave radiometers is proposed, which uses an accurate channel to calibrate another inaccurate channel in cloudy atmosphere. The simulation and measurements show that the method proposed here can eliminate the radiation of cloud liquid water and calibrate the radiometer under cloudy-sky conditions effectively. A relative tipping calibration is also introduced to retrieve the parameters in cloudy atmosphere. It has been proven that the relative tipping calibration can reduce the retrieval error significantly in cloudy atmosphere even though neither of the two channels is accurate. [ABSTRACT FROM PUBLISHER]

Continuous estimates of the vertical integrated precipitable water vapor content from the tropospheric delay of the signal received by the antennas of the global positioning system (GPS) are used in this paper, in conjunction with the measurements of the Meteosat Second Generation (MSG) spinning enhanced visible and infrared imager (SEVIRI) radiometer and with the lightning activity, collected here by the ground-based lightning detection network (LINET), in order to identify links and recurrent patterns useful for improving nowcasting applications. The analysis of a couple of events is shown here as an example of more general behavior. Clear signs appear before the peak of lightning activity on a timescale from 2 to 3 h. In particular, the lightning activity is generally preceded by a period in which the difference between SEVIRI brightness temperature (TB) at channel 5 and channel 6 (i.e., ∆TB) presents quite constant values around 0 K. This trend is accompanied by an increase in precipitable water vapor (PWV) values, reaching a maximum in conjunction with the major flash activity. The results shown in this paper evidence good potentials of using radiometer and GPS measurements together for predicting the abrupt intensification of lightning activity in nowcasting systems. [ABSTRACT FROM AUTHOR]

Accurate prediction of sea surface emission is the key for sea surface salinity retrieval from satellite microwave radiometer. In order to retrieve salinity from satellite observation, several sea surface microwave emission models have been developed based on theoretical or empirical methods and validated by in-situ measurements in different regions. However, their performances are still unclear in the Chinese coastal waters. In this study, based on two cruises measurements in the East China Sea (ECS), including the brightness temperature measured by a shipborne microwave radiometer and other auxiliary data (sea surface salinity, sea surface temperature and wind speed), the performances of different sea surface emission models are tested. The results showed that the developed models provide fairly good accuracy in predicting brightness temperature; for example, the accuracy of small perturbance/small scale approximation model (SPM/SSA), two-scale model (TSM) and empirical model is in the range from 0.6 K to 3 K. Moreover, the TSM and empirical models are further improved by optimizing the model parameters in the ECS. Finally, the sea surface salinity were retrieved from shipborne measured data based on the improved models, and the results show that the root mean square (rms) differences between retrieved and in-situ sea surface salinity is about 0.4 psu, indicating the significant improvement by the regional model parameters. [ABSTRACT FROM AUTHOR]

Accurate representation of the ocean-atmosphere coupling in weather, wave and climate models requires reliable estimates of air-sea surface fluxes of momentum, heat and mass. Whitecap fraction (W) usually quantifies the enhancement of the surface fluxes due to wave breaking. Satellite-based passive remote sensing of W from ocean surface brightness temperatures ( T B s) observes open ocean surface fluxes at low spatial resolution. Radiometric surface observations at higher resolution are necessary to monitor the complex environment in the coastal zone and in polar regions. We assess the feasibility of using the millimeter-wave frequencies (89 to 150 GHz) to observe whitecaps. We evaluate the derivative of the T B with respect to W as a measure for the observation of W. We describe the models and data used to evaluate the T B sensitivity to W for different instrumental and environmental conditions. Atmospheric absorption limits the ability to observe the surface at millimeter-wave frequencies. We find that the T B sensitivity to W at 89 GHz may be sufficient to support limited W retrieval from observations at altitudes below 1 km and that the T B sensitivity at 113 and 150 GHz is not sufficient. Clear skies, and low to moderate atmospheric humidity favor whitecap observations. [ABSTRACT FROM AUTHOR]