Search

In radio-frequency (RF)-based device-free localization (DFL), the number of sensors acting as RF transmitters and receivers is crucial for accuracy and system costs. Two promising approaches for DFL have been identified in the past: radio tomographic imaging (RTI) and multi-static radar (MSR). RTI in its basic version requires many sensors for high accuracy, which increases the cost. In this paper, we show how RTI benefits from multipath propagation. By evaluating the direct and echo paths, we increase the coverage of the target area, and by utilizing UWB signals, the RTI system is less susceptible to multipath propagation. MSR maps reflections that occur within the target area to reflectors such as persons or other objects. MSR does not require that the person is located near a signal path. Both suggested methods exploit ultra-wideband (UWB) channel impulse response (CIR) measurements. CIR measurements and the modeling of multipath effects either increase the accuracy or reduce the required number of sensors for localization with RTI. We created a test setup and measure UWB CIRs at different positions with a commercially available off-the-shelf UWB radio chip, the Decawave DW1000. We compare the localization results of RTI, multipath-assisted (MA)-RTI, and MSR and investigate a combined approach. We show that RTI is improved by the analysis of multipath propagation; furthermore, MA-RTI results in a better performance compared to MSR: with 50% of all cases, the localization error is better than 0.82 m and in 80% of all cases 1.34 m. The combined approach results in the best localization result with 0.64 m in 50% of all cases. [ABSTRACT FROM AUTHOR]

Foreign object debris (FOD) on airport runways can cause serious accidents and huge economic losses. FOD detection systems based on millimeter-wave (MMW) radar sensors have the advantages of higher range resolution and lower power consumption. However, it is difficult for traditional FOD detection methods to detect and distinguish weak signals of targets from strong ground clutter. To solve this problem, this paper proposes a new FOD detection approach based on optimized variational mode decomposition (VMD) and support vector data description (SVDD). This approach utilizes SVDD as a classifier to distinguish FOD signals from clutter signals. More importantly, the VMD optimized by whale optimization algorithm (WOA) is used to improve the accuracy and stability of the classifier. The results from both the simulation and field case show the excellent FOD detection performance of the proposed VMD-SVDD method. [ABSTRACT FROM AUTHOR]

Continuous respiration monitoring is important for predicting a potential disease. Due to respiration measurements using contact sensors, it is difficult to achieve continuous measurement because the sensors are inconvenient to attach. In this study, a radar sensor was used for non-contact respiration measurements. The radar sensor had a high precision and could even be used in the dark. It could also be used continuously regardless of time and place. The radar sensor relied on the periodicity of respiration to detect the respiration rate. A respiration adaptive interval was set and the respiration rate was detected through harmonic quefrency selection. As a result, it was confirmed that there was no difference between the respiratory rate measured using a respiration belt and the respiratory rate detected using a radar sensor. Furthermore, case studies on changes in the radar position and about measurement for long periods confirmed that the radar sensor could detect respiration rate continuously regardless of the position and measurement duration. [ABSTRACT FROM AUTHOR]