Search

This paper reports laboratory testing and numerical modelling on the cross-sectional behaviour and resistances of press-braked S690 high strength steel slender channel section stub columns under combined compression and minor-axis bending. A testing programme, including initial geometric imperfection measurements and ten minor-axis eccentric compression tests, was firstly conducted. This was accompanied by a numerical modelling programme, including a validation study, where finite element models were developed and validated against test results, and a series of parametric studies, where the validated finite element models were used to generate further numerical data. The obtained test and numerical data were then adopted to evaluate the current codified design interaction curves for press-braked S690 high strength steel slender channel section stub columns under combined compression and minor-axis bending, as provided in the European code, North American specification and Australian/New Zealand standard. The evaluation results revealed that the codified design interaction curves led to conservative and scattered resistance predictions, mainly due to the conservative end points (i.e. the cross-section compression and bending resistances). Finally, a new design interaction curve, anchored to more accurate end points, was proposed and shown to result in a higher level of design accuracy and consistency than the codified design interaction curves. • The behaviour of S690 high strength steel slender channel sections under minor-axis combined loading was studied. • Minor-axis eccentric compression tests were carried out. • FE models were developed and validated against the test results and then used to perform parametric studies. • The codified design interaction curves were evaluated, revealing a high level of conservatism. • A new interaction curve, anchored to the CSM end points, was proposed and shown to yield higher design accuracy. [ABSTRACT FROM AUTHOR]

This paper presents an experimental and numerical study of eccentrically loaded circular recycled aggregate concrete-filled stainless steel tube (RACFSST) stub columns. The testing programme was conducted on twelve specimens designed with different stainless steel tube section sizes and recycled coarse aggregate replacement ratios, and included tensile coupon tests, concrete cylinder tests and eccentric compression tests. The test results, including the failure loads and modes, load–mid-height lateral deflection curves and evolution of neutral axis, were reported and discussed. Following the testing programme, a numerical modelling programme was conducted, with finite element models developed and validated against the test results and then employed to perform parametric studies to generate further numerical data. The confinement effects were analysed based on the numerical data. The relevant design interaction curves, as set out in the European code, American specification and Australian/New Zealand standard, were assessed for their applicability to circular RACFSST stub columns under combined compression and bending. On the basis of the quantitative and graphical assessments, it has been found that (i) each set of codified design interaction curve leads to similar assessment results for eccentrically loaded circular RACFSST stub columns with different recycled coarse aggregate replacement ratios and (ii) the failure load predictions from the codified design interaction curves are conservative. • The structural behaviour and resistance of circular RACFSST stub columns under combined loading are investigated. • Twelve eccentric compression tests are conducted. • FE models are developed to validate against the test results and then used to conduct parametric studies. • The confinement effects of different types of RACFSST composite sections are discussed. • The applicability of the relevant codified N–M interaction curves is evaluated. [ABSTRACT FROM AUTHOR]