Search

The process of removing water from sewage sludge is particularly important due to its high content in the raw sludge. This translates into problems with the transport and storage of sediments. Additionally, high water content reduces the calorific value of the sludge. The methods for selecting the appropriate parameters for sewage sludge conditioning and filtration, based on the experimental data presented in this work, may allow for the optimization of sludge dewatering lines in small and large sewage treatment plants. The optimization of the dewatering process has a significant impact on the environmental and economic benefits, which consequently results in a decrease in the power costs of the devices used, flocculants, and sludge processing, and, above all, it contributes to the reduction in the negative impact on the environment. The use of mineral substances in the preparation of sewage sludge improves the effects of its dewatering in the pressure filtration process, as expressed in the obtained values of the final hydration and process efficiency. The use of polyelectrolytes alone significantly improves the effects of sewage sludge dewatering. In this work, the polyelectrolytes were supported by the addition of cement or zeolite. The conditioning of sewage sludge in combined methods using C-494 polyelectrolyte and minerals made it possible to reduce the compressibility coefficient to the range of 0.24–0.47 and, at the same time, to achieve the best results of sludge dewatering in the filtration process. The lowest hydration of 74.9% was achieved when polyelectrolyte and cement were added to the sludge, and this hydration was 6.5 percentage points lower compared to that of the non-filtered sludge. [ABSTRACT FROM AUTHOR]

Construction of the Włocławek Barrage on the Vistula River in 1970 became an important source of energy; however, it discontinued sediment transport in the Vistula River. This phenomenon resulted in accumulation before and erosion below the barrage; a similar problem can be expected due to the planned construction of the Lower Vistula Cascade. This study is dedicated to finding an effective and feasible solution to sediment transport management, acceptable to a wide group of users (e.g., navigation, energy producers, and ecologists). A numerical 1D model was applied to carry out analysis of hydrodynamics and sediment transport in the river section from Włocławek Barrage to the Vistula River mouth in the Baltic Sea. For calibration, historical data describing the accumulation and erosion created by the Włocławek Barrage were used. The proposed model allowed incorporation of new barrages chronologically, in accordance with the proposed time schedules. Analysis was carried out in a 50-year horizon, using a set of historical flow data. For sediment flushing, it was proposed to use natural flooding events exceeding Q10% discharge and to control sediment management of the adjacent barrages. To use this method in practice requires verification. [ABSTRACT FROM AUTHOR]