Search

Capacitive deionization (CDI) has been used to remove salt ions with carbon electrodes by the electrical double layer (EDL) mechanism. Other non-carbon materials based on pseudocapacitive mechanism resulting from faradaic reactions with fast electrosorption/desorption properties have emerged as new promising electrode materials. Until now, pseudocapacitive behavior was limited to thin film electrodes with nanometer thickness and was not yet suitable for practical application. In this work, we employed a two-times of hydrothermal synthesis process constructing MnFe 2 O 4 /Porous rGO (MFO/PrGO) nanostructure as pseudocapacitive electrodes. In this carefully designed architecture, the dense structure of MFO/rGO prepared by first-time hydrothermal process provided good connections of MFO nanoparticle with rGO framework for efficient redox charge transfer; the chemically-etched porous rGO used in the second-time hydrothermal process offered hierarchical pores for easier access of the electrode materials, both contributed in enhanced pseudocapacitive electrosorption. HRTEM verified the MnFe 2 O 4 spinel structure and measured the inter-planar lattice parameter which functioned for ion intercalating in and out of the electrode. The MFO/PrGO electrode resulted in 237 F/g in electrosorption of ions from aqueous solution which was higher than the MFO only electrode. Finally, in the CDI experiment, the great salt electrosorption capacity of 8.9 mg/g and 100% regeneration in multiple cycles were achieved by the MFO/PrGO nanocomposite electrode. These results paved the way for using spinel compounds and graphene nanocomposite electrodes for efficient electrosorption and desalination. [ABSTRACT FROM AUTHOR]

• La-doping HAP (La-HAP) was synthesized by hydrothermal method in the presence of LaCl 3. • LaHAP/3D-rGO composites with various ratios were obtained by simple ultrasonic mixing. • 50LaHAP/3D-rGO possesses good conductivity and high hydrophilicity. • 50LaHAP/3D-rGO delivers F− adsorption of 1132 μmol g−1 with high selectivity by CDI. • The selective removal of F- in actual high-fluorine groundwater is achieved. Excessive fluoride in water is severely hazardous to environment and human health. It is of great significance to exploit effective methods for defluoridation from water. In this paper, lanthanum-doped hydroxyapatite modified three-dimensional reduced graphene oxide (LaHAP/3D-rGO) was successfully synthesized with LaHAP uniformly distributed on the 3D network. Electrochemical characterization demonstrates the improvement of the conductivity and ion diffusion rate after doping appropriate amount of LaHAP. With LaHAP/3D-rGO as positive electrode (activated carbon as negative electrode), the corresponding capacitive deionization (CDI) system is successfully applied for the selective adsorption of fluoride. With the appropriate LaHAP/3D-rGO ratio (50%), the obtained LaHAP/3D-rGO electrode achieves the optimal F− adsorption amount of 1132 μmol g−1. The corresponding CDI cell shows excellent selectivity and high cycle stability for adsorption of fluoride. When applied to the fluoride removal in the fluoride-containing groundwater through a 3-cell CDI stack, the electrode attains the high F− removal rate of 90.5%, with the effluent concentration down to 0.32 mg L−1, much lower than the permissible limit of World Health Organization. This LaHAP/3D-rGO based CDI system is much promising for water purification of the high F− groundwater. [Display omitted] [ABSTRACT FROM AUTHOR]

Capacitive deionization (CDI) is an emerging technology as a sustainable low energy process for desalination of brackish water. Activated carbon electrodes are often used in the CDI devices. Electrosorption capacity was found to be improved on asymmetric electrode configuration using activated carbon cloth doped with fluorine due to redistribution of electric potential. This led to improvement in desalination performance up to 12.4 mg/g for a desalination cycle of 6 min employing an asymmetric fluorinated electrode as cathode (ACC//F-ACC). A relatively high charge efficiency of 77 % was obtained representing 92 % charge efficiency neglecting the leakage currents. Furthermore, the ion adsorption rate was found to improve substantially due to an increased surface conductivity of the fluorinated electrode confirmed by Mott-Schottky analysis. Energy consumption during desalination of 1000 ppm sodium chloride solution of 0.71kWh/m3 for symmetric electrode configuration was found to reduce by 36 % upon employing asymmetric configuration. This study shows some of the benefits of asymmetric configuration to achieve an optimal operation of CDI device, as well as improvements related to energy consumption. Image, graphical abstract [ABSTRACT FROM AUTHOR]