Search

In this study the numerical model Delft3D is implemented on high-resolution grids to evaluate beach morphological response to groins and submerged breakwaters under sea-breeze conditions. The numerical model is compared with field measurements from three sites on the northern Yucatan coast of Mexico. At these sites, relatively low energy waves with significant wave heights arrive at a steep oblique angle to the coast that drives high sediment transport rates. After calibration of the model, by adjustment of model free parameters, the model results show accurate representations of the diurnal variation of hydrodynamic conditions (wave height and current velocity) driven by the daily sea-breezes. Moreover, the morphodynamic model shows a good representation of the rapid morphological changes, particularly of the accretion pattern caused by a temporary groin and the subsequent recovery following the structure removal. However, erosion patterns at the downdrift areas of structures were not reproduced, owing to the numerical model limitations of simulating swash morphodynamics. Model validation with field observations of the beach response behind submerged breakwaters enabled the model to be used for a parametric study. Following previous work, new equations are developed in the present study that show an improvement for predicting shoreline changes near submerged breakwaters under sea-breeze conditions. Despite the limitations in reproducing downdrift erosion, overall the high-resolution modelling approach satisfactorily simulates the hydrodynamic and the updrift accretion responses to coastal structures on sandy beaches with oblique waves. • Simulations of beach change near groins and submerged breakwaters are performed. • Results are compared to measurements at three sites with high sediment transport rates. • New equations show improved prediction of shoreline change near submerged structures. [ABSTRACT FROM AUTHOR]

Abstract: A technique is described to observe and quantify wave-by-wave bed-level changes in the swash zone. The ultrasonic instrument system is non-contact with the beach face surface being measured and the sensors remain outside of the fluid flows causing sediment movement. Sensor resolution combined with the electronic noise inherent within a digital network data-logging system results in a (conservative) measurement accuracy of ±1 mm, equating to a couple of sand grain diameters in height. Illustrative field results demonstrate the practical use of the instrumentation, and a simple data pre-processing method to separate swashes and intervening bed-level ‘events’ is discussed. These example data reveal rather complex fluctuations of the bed observed over time periods of minutes to hours. Rather strikingly, gross bed-level changes per wave are revealed to be up to many orders of magnitude larger than the observed net rate of beach face evolution. It is outlined how observations of successive bed-level changes at multiple locations within a dense grid, combined with a consideration of sediment continuity, will now enable the total net sediment transported per uprush–backwash to be quantified. [Copyright &y& Elsevier]

The response of nourished beaches to sea level rise is investigated experimentally with random waves in a laboratory wave flume (20 m × 1 m × 1 m), following on from a previous investigation of the response of non-nourished beaches (Atkinson et al., 2018). The nourishments are placed on beach profiles previously exposed to sufficient durations of waves to have approached a near-equilibrium state, i.e., with stable shoreline, bars and berms. Nourishment was placed in three different locations: on the berm, within the bar trough, and as a shoreline placement. In the latter case, and following Bruun rule concepts (Bruun, 1962), the volume of sediment placed was estimated a priori to lead to zero recession under the chosen water level rise. The nourished beaches were then exposed again to sufficient durations of waves to reach a near-equilibrium state at the raised water level. The shoreline recession and the mean recession of the profile following a rise in water level are compared for both the nourished and non-nourished beaches, and to theoretical estimates based on Bruun rule concepts and a previously developed Profile Translation Model (PTM). Quantitative agreement is found with the variants of the Bruun Rule that account for nourishment and with the PTM, and the predicted recession is within an order of ±30% of the observed recession. Overall, the PTM provides the best estimate of the recession. The mean recession of the profile is found to be in better agreement with the model predictions than the recession measured at the shoreline, because the latter is affected by changes in profile shape around the still water line. The efficacy of the nourishment was investigated from the reduction in the observed recession. The efficacy depends on how the recession is measured. For the mean recession, highest efficacy was observed when all the nourishment is added into the active profile. Conversely, for the shoreline recession, highest efficacy was observed with the nourishment placed on the upper beach because it prevents additional recession through wave overtopping. • Direct comparison of nourishment and non-nourishment experiments. • Nourishment reduces recession associated with sea level rise. • Nourishment placed further landward reduces chance of loss of sediment offshore. • The effective nourishment volume is important to consider when predicting recession. [ABSTRACT FROM AUTHOR]