Search

This study investigates the effect of feedstock drying on the emissions of polycyclic aromatic hydrocarbons (PAHs) associated with the particulate matter (PM) produced during the co-generation of biochar and bioenergy. Raw pyrolysis volatile mixtures were generated from the pyrolysis of rice husk at 400, 500, 600, 700, and 800 °C using a laboratory-scale continuous pyrolysis-combustion system and combusted at 850 °C. PM samples from the combustion were collected and analysed for 15 priority PAH species with a gas chromatography/mass spectrometer (GC/MS). It was found that the utilization of the as received (AR) rice husk resulted in significantly greater energy-based yields of PM 10 (1.2 times at 400 °C and 1.6 times at 800 °C) than the dried rice husk. The majority of the increase was of the PM 2.1-10 size fraction. The PM-bound PAH concentration was found to be 2.1 and 2.8 times higher for the AR rice husk at 400 and 800 °C, respectively. This resulted in a significant increase in the energy-based yield of PAHs over the entire volatile production temperature range for the AR rice husk. Nevertheless, the majority of the PM-bound PAH species generated from the AR rice husk consisted of 2 and 3 ring PAHs (naphthalene, acenapthylene, and acenaphthene) with relatively low toxicity. The concentration of 4, 5, and 6 ring PAHs was generally lower than that generated from the dried rice husk. This resulted in the benzo( a )pyrene-equivalent toxicity of the PM generated from the AR rice husk being lower than the dried counterpart. [ABSTRACT FROM AUTHOR]

Biochar, i.e. pyrolysed biomass, as a soil conditioner is gaining increasing attention in research and industry, with guidelines and certifications being developed for biochar production, storage and handling, as well as for application to soils. Adding water to biochar aims to reduce its susceptibility to become air-borne during and after the application to soils, thereby preventing, amongst others, human health issues from inhalation. The Bagnold model has previously been modified to explain the threshold friction velocity of coal particles at different moisture contents, by adding an adhesive effect. However, it is unknown if this model also works for biochar particles. We measured the threshold friction velocities of a range of biochar particles (woody feedstock) under a range of moisture contents by using a wind tunnel, and tested the performance of the modified Bagnold model. Results showed that the threshold friction velocity can be significantly increased by keeping the gravimetric moisture content at or above 15% to promote adhesive effects between the small particles. For the specific biochar of this study, the modified Bagnold model accurately estimated threshold friction velocities of biochar particles up to moisture contents of 10%. [ABSTRACT FROM AUTHOR]