Search

Abstract: Co-P-B catalyst coatings have been synthesized on Ni-foam by using electroless deposition (ED) and their catalytic activity was investigated by catalytic dehydrogenation of ammonia borane (AB, NH3BH3) for H2 generation. Co-P-B catalyst (both in form of powder and coating) showed superior catalytic activity in hydrolysis reaction of AB than that of Co-B powder, with complete evolution of H2 (97%) at very high rate (2l/min/gcatalyst). This was mainly attributed to synergic effect caused by B and P over Co active sites to lower the activation energy of the process. For thermolysis reaction, it was observed that AB loaded on Co-P-B/Ni catalyst releases first mole of H2 at considerably low temperature starting at 50°C and with desorption peak centered at 80°C. To our knowledge this value is the lowest reported for solid state catalyst. Moreover, the catalytic thermolysis did not present any induction time and minimizes the formation of undesirable byproduct like borazine and ammonia. The present result suggests that Co-P-B coated on Ni is a highly efficient and low cost catalyst and can be used for both hydrolysis as well as thermolysis reaction of NH3BH3 with the important advantage that it can be easily recovered and repeatedly reused. [Copyright &y& Elsevier]

Abstract: Nanoparticle-assembled Co-B thin films were synthesized by Pulsed Laser Deposition (PLD) and used as catalysts for the hydrolysis of NH3BH3 (ammonia borane, AB) to produce molecular hydrogen. Amorphous Co-B-based catalyst powders, produced by chemical reduction of cobalt salts, were used as target material for Co-B thin film catalysts preparation through PLD. Surface morphology of Co-B powder and film catalyst was studied using Scanning Electron Microscopy (SEM) and Atomic Force Microscopy (AFM). Compositional and structural characterizations were carried out using X-photoelectron spectroscopy (XPS) and X-ray diffraction (XRD) techniques, respectively. The efficiency of both powder and film catalysts was tested by comparative kinetic analysis of the AB hydrolysis for hydrogen production. It was observed that nanoparticles produced during the laser ablation process act as active catalytic centers to produce significantly higher rate (about 6 times) of H2 than the same amount of the corresponding Co-B powders. Almost complete conversion (95%) of AB was obtained, as confirmed by 11B NMR, by using Co-B films at room temperature. Active Co-B nanoparticles on the surface of the PLD-deposited films is able to decrease the activation energy, for hydrolysis of AB, to the very low value of 34kJmol−1. We also found that by adding small amount of NaBH4 to the NH3BH3 solution increases the efficiency of the Co-B catalyst films, thus generating H2 with higher rate. Maximum H2 generation rate of about ∼8.2LH2 min−1 (g of Co)−1 and ∼13LH2 min−1 (g of Co)−1 was measured by hydrolysis of AB and mixture of (AB+NaBH4) solutions, respectively. [Copyright &y& Elsevier]

Abstract: Cr-modified Co–B (Co–Cr–B) catalyst alloy powders have been synthesized by chemical reduction of cobalt and chromium salt at room temperature to study the hydrogen production by catalytic hydrolysis of NaBH4. The Cr/Co molar ratio was varied in the catalyst in order to study the effect of Cr doping on surface modification and catalytic efficiency of Co–B catalyst. The resulting catalyst powders were characterized by scanning electron microscopy, X-ray diffraction, X-photoelectron spectroscopy, and BET surface area measurement. When the molar ratio χ Cr =Cr/(Cr+Co) exceeds 9% the BET surface area of the Co–Cr–B catalyst increases by one order of magnitude as compared to that of Co–B catalyst. The catalytic activity of the Co–Cr–B for hydrogen production depends on Cr concentration: specifically, the activity increases by increasing χ Cr up to about 4% and then it gradually decreases by further increasing χ Cr. We established that the increased catalytic activity is related to the formation of chromium oxide on the catalyst surface, with the oxide favoring the dispersion of Co–B particles resulting in high catalyst surface area. However as χ Cr exceeds 4%, Cr starts to cover the Co active sites and the corresponding catalytic activity decreases. The highest catalytic activity was obtained at the optimum Cr-content, χ Cr =4%, in Co–Cr–B catalyst, showing nearly 4 times higher H2 generation rate than that of pure Co–B catalyst. Kinetic studies on the hydrolysis reaction of NaBH4 with Co–Cr–B catalyst reveal that the concentrations of both NaBH4 and NaOH have essentially no effects on hydrogen generation rate. The promoting effect of Cr in Co–Cr–B catalyst results in lower activation energy for hydrogen production, which is 37kJmol−1 as compared to 45kJmol−1 obtained with pure Co–B powder. Finally, the possible role of Cr3+ species in the electron exchange mechanisms involved in NaBH4 hydrolysis with the Co–Cr–B catalyst has been discussed. [Copyright &y& Elsevier]